In mathematics, the Laurent series of a complex function is a representation of that function as a power series which includes terms of negative degree. It may be used to express complex functions in cases where a Taylor series expansion cannot be applied. The Laurent series was named after and first published by Pierre Alphonse Laurent in 1843. Karl Weierstrass may have discovered it first in a paper written in 1841, but it was not published until after his death.[1]
![](http://upload.wikimedia.org/wikipedia/commons/thumb/5/5a/Laurent_series.svg/256px-Laurent_series.svg.png)
Definition
editThe Laurent series for a complex function about a point
is given by
The path of integration is counterclockwise around a Jordan curve enclosing
and lying in an annulus
in which
is holomorphic (analytic). The expansion for
will then be valid anywhere inside the annulus. The annulus is shown in red in the figure on the right, along with an example of a suitable path of integration labeled
. If we take
to be a circle
, where
, this just amountsto computing the complex Fourier coefficients of the restriction of
to
. The fact that these integrals are unchanged by a deformation of the contour
is an immediate consequence of Green's theorem.
One may also obtain the Laurent series for a complex function at
. However, this is the same as when
(see the example below).
In practice, the above integral formula may not offer the most practical method for computing the coefficients for a given function
; instead, one often pieces together the Laurent series by combining known Taylor expansions. Because the Laurent expansion of a function is unique wheneverit exists, any expression of this form that equals the given function
in some annulus must actually be the Laurent expansion of
.
Convergent Laurent series
edit![](http://upload.wikimedia.org/wikipedia/commons/thumb/3/33/Expinvsqlau_SVG.svg/220px-Expinvsqlau_SVG.svg.png)
![](http://upload.wikimedia.org/wikipedia/commons/thumb/5/54/Expinvsqlau_GIF.gif/220px-Expinvsqlau_GIF.gif)
Laurent series with complex coefficients are an important tool in complex analysis, especially to investigate the behavior of functions near singularities.
Consider for instance the function with
. As a real function, it is infinitely differentiable everywhere; as a complex function however it is not differentiable at
. By replacing
with
in the power series for the exponential function, we obtain its Laurent series which converges and is equal to
for all complex numbers
except at the singularity
. The graph opposite shows
in black and its Laurent approximations
More generally, Laurent series can be used to express holomorphic functions defined on an annulus, much as power series are used to express holomorphic functions defined on a disc.
Suppose
- The Laurent series converges on the open annulus
. To say that the Laurent series converges, we mean that both the positive degree power series and the negative degree power series converge. Furthermore, this convergence will be uniform on compact sets. Finally, the convergent series defines a holomorphic function
on the open annulus.
- Outside the annulus, the Laurent series diverges. That is, at each point of the exterior of
, the positive degree power series or the negative degree power series diverges.
- On the boundary of the annulus, one cannot make a general statement, except to say that there is at least one point on the inner boundary and one point on the outer boundary such that
cannot be holomorphically continued to those points.
It is possible that may be zero or
may be infinite; at the other extreme, it's not necessarily true that
is less than
.These radii can be computed as follows:
We take to be infinite when this latter lim sup is zero.
Conversely, if we start with an annulus of the form and a holomorphic function
defined on
, then there always exists a unique Laurent series with center
which converges (at least) on
and represents the function
.
As an example, consider the following rational function, along with its partial fraction expansion:
This function has singularities at and
, where the denominator of the expression is zero and the expression is therefore undefined.A Taylor series about
(which yields a power series) will only converge in a disc of radius 1, since it "hits" the singularity at 1.
However, there are three possible Laurent expansions about 0, depending on the radius of :
- One series is defined on the inner disc where |z| < 1; it is the same as the Taylor series, This follows from the partial fraction form of the function, along with the formula for the sum of a geometric series,for
.
- The second series is defined on the middle annulus where
is caught between the two singularities:
Here, we use the alternative form of the geometric series summation,for.
- The third series is defined on the infinite outer annulus where
, (which is also the Laurent expansion at
)
This series can be derived using geometric series as before, or by performing polynomial long division of 1 by, not stopping with a remainder but continuing into
terms; indeed, the "outer" Laurent series of a rational function is analogous to the decimal form of a fraction. (The "inner" Taylor series expansion can be obtained similarly, just reversing the term order in the division algorithm.)
The case ; i.e., a holomorphic function
which may be undefined at a single point
, is especially important. The coefficient
of the Laurent expansion of such a function is called the residue of
at the singularity
; it plays a prominent role in the residue theorem. For an example of this, consider
This function is holomorphic everywhere except at .
To determine the Laurent expansion about , we use our knowledge of the Taylor series of the exponential function:
We find that the residue is 2.
One example for expanding about :
Uniqueness
editSuppose a function holomorphic on the annulus
has two Laurent series:
Multiply both sides by , where k is an arbitrary integer, and integrate on a path γ inside the annulus,
The series converges uniformly on , where ε is a positive number small enough for γ to be contained in the constricted closed annulus, so the integration and summation can be interchanged. Substituting the identity
Hence the Laurent series is unique.
Laurent polynomials
editA Laurent polynomial is a Laurent series in which only finitely many coefficients are non-zero. Laurent polynomials differ from ordinary polynomials in that they may have terms of negative degree.
Principal part
editThe principal part of a Laurent series is the series of terms with negative degree, that is
If the principal part of is a finite sum, then
has a pole at
of order equal to (negative) the degree of the highest term; on the other hand, if
has an essential singularity at
, the principal part is an infinite sum (meaning it has infinitely many non-zero terms).
If the inner radius of convergence of the Laurent series for is 0, then
has an essential singularity at
if and only if the principal part is an infinite sum, and has a pole otherwise.
If the inner radius of convergence is positive, may have infinitely many negative terms but still be regular at
, as in the example above, in which case it is represented by a different Laurent series in a disk about
.
Laurent series with only finitely many negative terms are well-behaved—they are a power series divided by , and can be analyzed similarly—while Laurent series with infinitely many negative terms have complicated behavior on the inner circle of convergence.
Multiplication and sum
editLaurent series cannot in general be multiplied.Algebraically, the expression for the terms of the product may involve infinite sums which need not converge (one cannot take the convolution of integer sequences).Geometrically, the two Laurent series may have non-overlapping annuli of convergence.
Two Laurent series with only finitely many negative terms can be multiplied: algebraically, the sums are all finite; geometrically, these have poles at , and inner radius of convergence 0, so they both converge on an overlapping annulus.
Thus when defining formal Laurent series, one requires Laurent series with only finitely many negative terms.
Similarly, the sum of two convergent Laurent series need not converge, though it is always defined formally, but the sum of two bounded below Laurent series (or any Laurent series on a punctured disk) has a non-empty annulus of convergence.
Also, for a field , by the sum and multiplication defined above, formal Laurent series would form a field
which is also the field of fractions of the ring
of formal power series.
See also
edit- Puiseux series
- Mittag-Leffler's theorem
- Formal Laurent series – Laurent series considered formally, with coefficients from an arbitrary commutative ring, without regard for convergence, and with only finitely many negative terms, so that multiplication is always defined.
- Z-transform – the special case where the Laurent series is taken about zero has much use in time-series analysis.
- Fourier series – the substitution
transforms a Laurent series into a Fourier series, or conversely. This is used in the q-series expansion of the j-invariant.
- Padé approximant – Another technique used when a Taylor series is not viable.
References
edit- ^ Rodriguez, Rubi; Kra, Irwin; Gilman, Jane P. (2012), Complex Analysis: In the Spirit of Lipman Bers, Graduate Texts in Mathematics, vol. 245, Springer, p. 12, ISBN 9781441973238.