How to Restart a Dry Ball Point Pen

Ballpoint pens have smooth ink that’s resistant to drying and wonderfully responsive to different levels of pressure. Unfortunately, they also tend to suddenly stop working. If you’ve tried scribbling in circles on a piece of scrap paper with no success, don’t give up on your pen just yet. Try a simple hack like heating up the nib or dipping it in a household solvent to get the ink flowing again. Keep in mind that ballpoint pens can’t always be saved, however, so you may need to replace your pen or cartridge if these tricks don’t work.

Things You Should Know

Put the pen in boiling water for 5 minutes or warm it with a blow dryer. Alternatively, hold the tip close to a flame for a few seconds.
Dab spit on the nib to lubricate your pen or dip the point in rubbing alcohol. If the alcohol doesn’t work, dip the pen in acetone instead.
Scrape the nib against a rubber surface to unstick the ball. Shake the pen up and down to move the ink cartridge or push the ink down with a cotton swab.

Method 1

Method 1 of 3:

Using Heat to Revive Your Pen

Download Article

1
Put the pen in boiling-hot water for 5 minutes to avoid using flames. If you’re worried about burning yourself or your pen, use hot water to warm up the ink.^{[1]XResearch source} Heat some water to boiling in a kettle or in a pan on the stove, then pour it into a mug. Set the pen tip-down in the water for about 5 minutes, then test it out on a piece of paper.
- If your pen has any metal components, dry them thoroughly to prevent corrosion. You can also take the pen apart and soak just the cartridge if you don’t want to get the barrel of the pen wet.
2
Warm the pen with a blow dryer or craft heat gun for gentler heating. If you’re worried that an open flame or boiling water will be too harsh, warm the nib and cartridge with a hair dryer on a high heat setting. For slightly more powerful heating, you can also use a craft heat gun or embossing gun. Warm the nib of the pen for a few seconds at a time, then try writing with it.^{[2]XResearch source}
- Don’t use an industrial heat gun! They get extremely hot and will probably melt your pen.
Advertisement
3
Hold the tip of the pen to a flame for a few seconds to unclog the ink. Use a lighter, match, or candle to create a flame, then place just the very tip of your pen in the flame for a few seconds. In many cases, the heat will melt any gummed-up ink near the tip and get the pen working again.^{[3]XResearch source}
- Be careful not to burn yourself or melt the pen. Hold just the very tip of the nib in the flame, and don’t do it for longer than 2-3 seconds.
- If you’re worried about melting the barrel of your pen, remove the cartridge first. That way, it’s easier to just heat the nib of the pen.
- Scribble on some paper right away to get the ink moving and check if your pen works.
Tip: Wrapping a little aluminum foil around the tip of your pen can also help insulate it from the flame. However, it may take longer for the ink to warm up enough to start flowing again.^{[4]XResearch source}

Method 2

Method 2 of 3:

Getting the Ink Flowing with Solvents

Download Article

1
Dab a little spit on the nib to lubricate the ball. This may sound gross, but spit can act as a lubricant or gentle solvent to help unclog the tip of your pen. If you’re hesitant to actually lick the nib of your pen, put a little spit on your fingertip or a napkin and dip the pen tip in that. Then, scribble on a piece of paper to see if you can get the ink flowing.^{[5]XResearch source}
- Ballpoint pen ink is generally not considered toxic, so don’t worry about getting sick from licking the pen. Any mildly toxic components, such as glycols, are present in such small amounts that they won’t cause any harm.^{[6]XResearch source}
2
Dip the point of the pen in rubbing alcohol to dissolve clogs. If some of the ink is dried out in the pen, you might be able to get it going by thinning it a little with rubbing alcohol. Pour some alcohol into a cup or bowl and dip the pen into it, then scribble on a piece of paper to see if you can get it flowing again.^{[7]XResearch source}
- Most ballpoint pens have oil-based ink, which is part of the reason it’s so hard to get ballpoint stains out of clothing. Solvents, such as alcohol, are better at thinning oil-based ink than plain water.
3
Try acetone if alcohol doesn’t work. Acetone is a more aggressive solvent that might unclog your pen if alcohol isn’t strong enough. Dip the nib of your pen in a little bit of acetone-based nail polish remover and see if that does the trick.^{[8]XResearch source}
- Acetone releases harsh fumes, so always use it in a well-ventilated area.
- Try to dip only the very tip of the pen in the acetone, since acetone can damage many types of plastic.^{[9]XResearch source}
Tip: If you don’t have alcohol or acetone on hand, kerosene, odorless mineral spirits, or WD-40 might work.

Method 3

Method 3 of 3:

Moving Stuck Ink with Friction and Gravity

Download Article

1
Scrape the nib on a rubber surface to get the ball rolling. When scribbling on paper doesn’t work, sometimes you can get a stuck ball moving by rubbing the pen on a rubber surface. Scribble on a rubber eraser or even the sole of your shoe.^{[10]XResearch source}
- Alternatively, some people find it helpful to scribble on a glass surface (such as a hand mirror) to get a stuck ballpoint pen going again.^{[11]XResearch source}
2
Shake the pen to move the ink down in the cartridge. Sometimes a ballpoint pen will stop writing because there’s a space or bubble between the ink in the cartridge and the nib. Hold the end of your pen opposite the nib and give the pen several firm shakes, as if you were shaking down an old-fashioned glass thermometer. When you’re done, give it a scribble to see if it works.^{[12]XResearch source}
- You can also try tapping the pen firmly on a hard surface, like the edge of a desk or table.
Tip: To keep the ink from flowing away from the nib, store your ballpoint pens tip-down in a mug or pen holder.
3
Push the ink down in a wide cartridge with a cotton swab. If your pen has a wide enough cartridge, you may be able to push the ink down toward the nib. Unscrew the barrel of your pen and take out the cartridge, then pull the cap off the end of the cartridge. Push a cotton swab into the cartridge and apply gentle pressure to the fluid inside. Put your pen back together and test it again.^{[13]XResearch source}
- If the cartridge is too narrow to fit a cotton swab in, use a smaller object, like a paperclip.
- If the cotton swab gets ink on it, toss it in the trash right away so that the ink doesn’t spread around and stain anything.

Community Q&A

Search

Add New Question

Question
How do I get a Zebra Orbit pen to work again?
How.com.vn Staff Editor
Staff Answer
This answer was written by one of our trained team of researchers who validated it for accuracy and comprehensiveness.
How.com.vn Staff Editor
Staff Answer
First of all, try checking the cartridge to see if it looks like there's still ink inside. If not, your pen might need a refill. You can purchase new cartridges online or from an office supply store. Otherwise, try running hot water over the nib to get the ink flowing and dissolve clogs, or shake your pen to get any bubbles out.
Thanks! We're glad this was helpful.
Thank you for your feedback.
If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn
Yes No
Not Helpful 10 Helpful 17
Question
What do I do if my dry ball point pen is dispensing ink poorly?
How.com.vn Staff Editor
Staff Answer
This answer was written by one of our trained team of researchers who validated it for accuracy and comprehensiveness.
How.com.vn Staff Editor
Staff Answer
If the ink is skipping a lot, there could be bubbles or a clog in the ink. Heating the cartridge in warm water might help loosen things up. You can also try dipping the nib in alcohol or another solvent to dissolve any clogs.
Thanks! We're glad this was helpful.
Thank you for your feedback.
If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn
Yes No
Not Helpful 11 Helpful 26
Question
Are the Scribble Stuff pens usable for this type of process?
How.com.vn Staff Editor
Staff Answer
This answer was written by one of our trained team of researchers who validated it for accuracy and comprehensiveness.
How.com.vn Staff Editor
Staff Answer
If you're using the gel pens, dipping the cartridge in warm or hot water might work. Most Scribble Stuff pens have marker tips and are not ballpoint pens, so you might have to use a different technique for those (such as injecting water into the tips or soaking them in vinegar).
Thanks! We're glad this was helpful.
Thank you for your feedback.
If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn
Yes No
Not Helpful 16 Helpful 21

See more answers

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Video

Read Video Transcript

Reader Videos

Tips

While some of these tricks might help, there’s no totally reliable method for getting a ballpoint pen working again. If your pen is still being stubborn and you can’t easily replace the cartridge, it may be time to get a new pen.
Thanks
Helpful9 Not Helpful3
Some fancier ballpoint pens have cartridges that can be replaced or refilled. If you’re determined to keep your ballpoint pen but you just can’t get the ink flowing, check online or visit your local office supply store to see if you can purchase a refill. Make sure to get one that’s designed for your type of pen.
Thanks
Helpful8 Not Helpful6
Some new ballpoint pens or cartridges have a tiny plastic cap over the nib to protect it and prevent leaks. Make sure to remove that so that your pen can write.
Thanks
Helpful5 Not Helpful3

Show More Tips

- If you are using a erasable/friction pen, by heating it you are making the ink "disappear". If you heat, put in the fridge or freezer for a couple minutes tip down and try pen again.

Show More Tips

Tips from our Readers

The advice in this section is based on the lived experiences of How.com.vn readers like you. If you have a helpful tip you’d like to share on How.com.vn, please submit it in the field below.

Heat up a cup of water in the microwave, and place the pen in the water for a couple of minutes. Take the pen out of the water, wipe it off, and write until the ink flows.
When trying the lighter tip, avoid doing it for more than a second. The tip of the pen could blow off of the plastic part and spray ink.
If you're using a borrowed pen and don't want to lick it, try spitting on your forearm and swirling the pen point in the wet spot.

Submit a Tip

All tip submissions are carefully reviewed before being published

Submit

Thanks for submitting a tip for review!