Download ArticleDownload ArticleThis article was co-authored by Shaelynn Haning. Shaelynn Haning is a Tailor & Business Owner based in Tulsa, Oklahoma. Shaelynn is the founder of the highest-rated and most-reviewed alterations and tailoring service in Oklahoma, Tallgrass Tailor, employing a team of skilled craftsmen and women from across the country and the world. Shaelynn is a member of the State of Oklahoma Education Careers and Technologies Board and a member of both the Custom Tailors and Designers Association and the Association of Sewing and Design Professionals. She is the host of The Sew Show with Shae, an entertaining and educational sewing channel posting weekly videos on YouTube. Shaelynn earned her BS in Apparel Design and Product Development from Marist College.
There are 8 references cited in this article, which can be found at the bottom of the page.
This article has been viewed 49,669 times.
Tying a knot in a single strand after you've threaded your embroidery needle is helpful when you're starting a new project. There are two main ways to tie the knots, and all you'll need is a needle, thread, and scissors. Make a simple knot for an easy method, or wrap the thread around your needle to make a knot that's big. The most important thing to remember is to make a knot that's thick enough that it won't slide through the eye of your needle. With just a few seconds of time, your thread will be knotted and ready!
Steps
Thread the needle by sliding the thread through the needle’s eye. Cut a strand of thread long enough for your specific project using sharp scissors so the end doesn’t fray. Carefully slide the end of the thread through the eye of the needle and pull the thread through so it doesn’t fall back out.[1]- Wetting the end of your thread makes it easier to slip through the eye hole.
Wrap the thread around your finger to form a small loop. Take the end of the thread where you’d like to form the knot and wrap it around your finger. Hold the thread together and take your finger out to reveal a loop.[2]Advertisement- Push the tail end of the thread through the loop. Tuck the loose end of your thread through the loop. If the thread is too short to go through the loop and stay there, try making your loop over again and leaving yourself more thread to stick through the loop.[3]
- Pull the thread tight to form the knot. Tug on the end of the thread that you put through the loop so that it tightens. Once the thread is pulled as tightly as possible, you have your knot![4]
- Add 2-3 more knots on top of the first knot to make it thicker, if needed. If your thread is especially thin, it’s important to make a couple more knots on top of the first one so that your knot won’t slide through the eye of the sewing needle. Repeat the same steps to make additional knots, but be careful to tie your knots right on top of the first one so that it creates a larger clump.
- Guide the second or third knots over the first knot using your fingers.
EXPERT TIPShaelynn Haning is a Tailor & Business Owner based in Tulsa, Oklahoma. Shaelynn is the founder of the highest-rated and most-reviewed alterations and tailoring service in Oklahoma, Tallgrass Tailor, employing a team of skilled craftsmen and women from across the country and the world. Shaelynn is a member of the State of Oklahoma Education Careers and Technologies Board and a member of both the Custom Tailors and Designers Association and the Association of Sewing and Design Professionals. She is the host of The Sew Show with Shae, an entertaining and educational sewing channel posting weekly videos on YouTube. Shaelynn earned her BS in Apparel Design and Product Development from Marist College.Professional Tailor & Business Owner
Shaelynn Haning
Professional Tailor & Business OwnerMatch embroidery floss to the right needle. Embroidery floss is shiny, thin, and twisted so a sharp, thin needle works best. This makes it easier to poke the fabric and pull the thread for detailed work. The right needle improves how your embroidery looks and how easy it is.
Thread your needle so it’s ready to form a knot. Cut a strand of thread in whichever color you’d like to use for your project. Slide an end of the thread through the eye of the needle and pull that end through 2–3 in (5.1–7.6 cm) so it won’t fall back through.- It helps to wet the end of the thread before you slide it through the needle’s eye.
- Your knot will be made at the end of the thread.
- Make a small ‘X’ with the needle and loose end of the thread. Form a large loop so that the tip of your needle is facing the end of your thread. With just the tips of the needle and thread, form an 'X' shape by crossing the needle underneath the end of the thread. Hold this up in the air so you can manipulate it easier.[5]
- Hold your needle in one hand and the loose thread end in the other hand.
- Hold the loose thread end against the needle so it doesn’t move. Use your finger to press the thread against the needle to keep it in place. It’s important that this end doesn’t move around so that your knot forms easily.[6]
- Wrap the thread around the needle point 2-3 times. Take the thread near the tip of the needle and begin wrapping it around the needle. Do this 2-3 times, or until your knot is bigger than the needle's eye so it won't slip through. Wrap the thread tightly so it’s right against the needle.[7]
- Wrapping the thread around the needle 3 times will give you a bigger knot than only wrapping it around the needle twice.
- Pull the needle up while holding onto the wrapped thread to make a knot. Use one finger to hold the wrapped section of thread in place while you use the other hand to pull up on the needle. The wrapped section will slide down and off the needle. Keep pulling the needle up until the wrapped thread forms a knot near the end.[8]
- This is similar to how you might make a French knot while embroidering.
Expert Q&A
- QuestionWhat is the best needle to use for an embroidery floss?
Shaelynn HaningShaelynn Haning is a Tailor & Business Owner based in Tulsa, Oklahoma. Shaelynn is the founder of the highest-rated and most-reviewed alterations and tailoring service in Oklahoma, Tallgrass Tailor, employing a team of skilled craftsmen and women from across the country and the world. Shaelynn is a member of the State of Oklahoma Education Careers and Technologies Board and a member of both the Custom Tailors and Designers Association and the Association of Sewing and Design Professionals. She is the host of The Sew Show with Shae, an entertaining and educational sewing channel posting weekly videos on YouTube. Shaelynn earned her BS in Apparel Design and Product Development from Marist College.
Professional Tailor & Business OwnerThe embroidery floss is glossy, thin, and slippery, so you're going to want a sharp, thin needle that won't have any trouble piercing the fabric and pulling that thread through with it.
Video
Tips
- Practice tying the knots on a spare piece of thread before starting your project, if you'd like.Thanks
- Start off with a thick piece of thread to make tying the knots easier.Thanks
Warnings
- Be careful when working with the needle so that you don't accidentally poke your fingers.Thanks
Expert Interview
Thanks for reading our article! If you’d like to learn more about embroidery, check out our in-depth interview with Shaelynn Haning.
References
- ↑ https://www.youtube.com/watch?v=PQklQCBWEWI#t=5s
- ↑ https://www.youtube.com/watch?v=nUl3YN3cFYY#t=5m45s
- ↑ https://www.youtube.com/watch?v=PQklQCBWEWI#t=15s
- ↑ https://www.youtube.com/watch?v=nUl3YN3cFYY#t=5m51s
- ↑ https://www.youtube.com/watch?v=PQklQCBWEWI#t=1m2s
- ↑ https://www.youtube.com/watch?v=PQklQCBWEWI#t=1m8s
- ↑ https://www.youtube.com/watch?v=iPbSiyKXrbI#t=5s
- ↑ https://www.youtube.com/watch?v=iPbSiyKXrbI#t=8s
About This Article
Did this article help you?
⚠️ Disclaimer:
Content from Wiki How English language website. Text is available under the Creative Commons Attribution-Share Alike License; additional terms may apply.
Wiki How does not encourage the violation of any laws, and cannot be responsible for any violations of such laws, should you link to this domain, or use, reproduce, or republish the information contained herein.
- - A few of these subjects are frequently censored by educational, governmental, corporate, parental and other filtering schemes.
- - Some articles may contain names, images, artworks or descriptions of events that some cultures restrict access to
- - Please note: Wiki How does not give you opinion about the law, or advice about medical. If you need specific advice (for example, medical, legal, financial or risk management), please seek a professional who is licensed or knowledgeable in that area.
- - Readers should not judge the importance of topics based on their coverage on Wiki How, nor think a topic is important just because it is the subject of a Wiki article.
