How to Take Your Own Pulse With a Stethoscope

Whether you are simply curious or have been advised by a doctor, you can use a stethoscope to listen to your own heartbeat and measure your pulse. This article will walk you through how to use a stethoscope on yourself, how to count your heartbeats, and how to turn your measurement into a BPM calculation. Read on for more info!

1

Purchase a stethoscope if you do not already have one.

Download Article

You are only counting and will not need to listen to quality. Spending a max of 20-30 dollars for the double-tubed "Sprague" type will do just fine.

2

Find a way to keep time.

Download Article

A watch with a second hand is much easier than a digital watch because you do not have to count the seconds, you can just look at where the second hand should end up on your watch at the end of the time that you want.

3

Take off unnecessary layers.

Download Article

Depending on the quality of your stethoscope you can usually listen through about two T-shirt layers of clothing (just for the beats, not quality). Take any extra heavy clothing off if you cannot hear your heart clearly.

4

Place the earpieces in your ears.

Download Article

The earpieces of the stethoscope are usually angled and in order to hear correctly and have them be comfortable you need to place the tips in facing FORWARD, in the direction that you are looking. If they are not comfortable, you may gently bend them forward or backwards to get a good fit.^{[1]XResearch source}

5

Check to see if you can hear a sound.

Download Article

Many stethoscopes have chestpieces with two sides that can be rotated around the tubing to better hear high frequency and low frequency lung sounds, a diaphragm and a bell. When one is in use the other cannot be used. With the earpieces in your ears, GENTLY rub the diaphragm side (the one with the flat plastic piece) of the stethoscope and listen for a sound. If you do not hear a sound, turn the chest piece over (you should hear it click into position) and try again. This should resolve any issues.^{[2]XResearch source}

6

Position the chestpiece correctly.

Download Article

You want to put the chestpiece diaphragm side down on that line slightly to your left of center. Experiment to find where you can hear your heart best. If you are having trouble and still cannot find it, it may be helpful to lie down or lean forward slightly while doing this.^{[3]XResearch source}

7

Get your timepiece ready to watch.

Download Article

When you listen to the heart, remember that it has TWO beats, which represent the succession of valves in your heart contracting to pump blood (lub-dub lub-dub). HOWEVER ONLY ONE OF THOSE BEATS IS COUNTED IN YOUR PULSE. The first beat is usually stronger and it is recommended only listening to that beat and tuning the first one out.^{[4]XResearch source}

8

Start counting.

Download Article

Look at the second hand on your watch/clock, and when the second hand hits one of the 5 minute markers start counting the beats through your scope. In a clinical setting they typically count the pulse for 30 SECONDS as this is the minimum that is considered accurate. As mentioned earlier, you do not need to note each time the second hand moves, keeping track of that is too much work! Instead, look at where the second hand WILL end up at the end of 30 seconds.
- For example, if you start counting at the "2" mark, the hand will have passed 30 seconds at the "8" marker, or if you start at 12, 30 sec. will be at 6. Stop counting beats when the second hand reaches the marker and 30 seconds have elapsed. If you would like to be even more accurate (because the pulse is not always completely regular), you may count beats for 1 minute.^{[5]XResearch source}

9

Calculate BPM.

Download Article

If you counted for an entire minute you are all set and have your pulse. However, in most cases you now need to do a little math because pulse values are expressed in beats per minute (BPM). You counted the beats for 30 seconds, but as there are 60 seconds per minute you must multiply that by 2 to get beats per 60 seconds.
- For example, if you counted your pulse at 36 beats over 30 seconds, your pulse would be 72 because 36beats/30seconds = 72beats/60seconds. If, for some reason, you counted beats for only 15 seconds (as is sometimes done in moving ambulances because taking pulses is a PAIN in there), you would need to multiply by 4 as 15 x 4 = 60 = bpm.^{[6]XResearch source}

10

Repeat if required.

Download Article

For example, if your measured pulse is 15-20 bpm off your normal, you should definitely repeat this process to make sure you were accurate, and repeat successively until your measurements are relatively similar. And that's all there is to it.

Expert Q&A

Search

Add New Question

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Tips

It's not a great idea to place your thumb over the bell (unused side) of the stethoscope when holding it because the thumb has its own pulse and could mess your count up. You might like to hold it with your thumb and index fingers spread out and parallel, with the sides of the chestpiece in the space between them.^{[7]XTrustworthy SourceNational Health Service (UK)Public healthcare system of the UKGo to source}
Thanks
Helpful2 Not Helpful0
If you don't want to take clothing off it is also possible to place the stethoscope over the brachial artery, at the space where your elbow bends. To do this, expose your elbow and outstretch your arm so it is flat and put the diaphragm down, you will have to gently and slowly press softer to harder on your arm until you hear your pulse. For this you count all beats.^{[8]XResearch source}
Thanks
Helpful2 Not Helpful0
You should consider using the stethoscope on bare skin to prevent it from picking up the sound of rustling fabric. The fabric can also soak up the sound and make your heart sound faint.
Thanks
Helpful1 Not Helpful0

Show More Tips

Submit a Tip

All tip submissions are carefully reviewed before being published

Submit

Thanks for submitting a tip for review!

Warnings

If you do happen to hear anything other than the standard "lub-dub" sounds when you are listening to your heart, it may be beneficial to talk to your doctor about them, especially if you are feeling unusually sick. This would include anything you hear between "lub" and "dubs" or anything particularly high-pitched. Listen to recordings of normal heart sounds online to get an idea what your heart should sound like (although note that there is variation).
Thanks
Helpful2 Not Helpful0
Be careful not to bump anything with the chestpiece of the stethoscope while it is in you ears, the sound will carry and this is loud and unpleasant!
Thanks
Helpful2 Not Helpful0