Download ArticleDownload ArticleThis article was co-authored by Simon Miyerov. Simon Miyerov is the President and Driving Instructor for Drive Rite Academy, a driving academy based out of New York City. Simon has over 8 years of driving instruction experience. His mission is to ensure the safety of everyday drivers and continue to make New York a safer and efficient driving environment.
How.com.vn marks an article as reader-approved once it receives enough positive feedback. In this case, 88% of readers who voted found the article helpful, earning it our reader-approved status.
This article has been viewed 702,570 times.
When first learning to drive, you were most likely taught to adjust a car’s mirrors before driving it for the first time. You were then likely warned about the blind spots on each side, which you should always check before changing lanes or turning. However, it is possible to adjust a car’s mirrors in a way that eliminates these blind spots, meaning that only a quick glance becomes necessary before changing lanes. You’ll need to start by adjusting the side and center rear view mirrors, then confirm they overlap properly.
Steps
Lean your head over to the left and adjust the mirror. You should be leaning so that your head almost touches the driver's window. If your mirror is adjusted in the traditional fashion, the side of your car should almost take up the whole mirror. Correct this by adjusting the mirror until you can just see the rear quarterpanel (the rear end of the car).[1] If you’ve adjusted the mirror correctly, the rear of your car should occupy less than a third of the mirror.
Lean your head to the right and adjust your side mirror. Your head should be as close to the center as you can without having to leave your seat. From there, position the right side mirror so you can just see the rear quarterpanel of the passenger side in the mirror.[2] Again, ensure the quarterpanel takes up less than a third of the mirror’s view.Advertisement
Return to your usual position in the driver’s seat and adjust the center rearview mirror. Place this mirror to see as much of your rear window as you can. You want to see directly out of the rear of your vehicle; don’t try tilting the mirror to get a better view of traffic on either side.[3] The center mirror should compensate for what the side mirrors can’t see, not compensate for badly adjusted side mirrors.
Check the adjustment of your mirrors from a normal, seated driving position. You shouldn’t be able to see your car at all in either side mirror, giving you a much wider view.[4] If you can still see the side of your car in either mirror, try the above steps again. You’ll likely need to adjust the mirrors so they point further outward.
Confirm the additional view provided by your side mirrors after proper adjustment. Your mirrors should now cover more of the lanes right next to your car. Not only can you keep track of cars behind you and to the side, but you can follow them visually as they approach, going a long way to eliminating your car’s blind spots.[5] While you’ll still want to perform a quick shoulder check for added safety when changing lanes, you’ll now have a better view of vehicles and objects to the sides.
Check to ensure objects to the rear transition to the side mirrors as they pass you. Pay particular attention to cars passing you. As they approach, you should first see them in the center rear view mirror. Then, as they pass you, they’ll move laterally through your center rear view mirror until they appear in the corresponding side mirror. This transition should be smooth; the vehicle should be reflected by your side mirror as soon as it leaves the center mirror. This confirms the elimination of your car’s blind spots.- If there is a pause between the vehicle leaving the center mirror and appearing on your side mirror, you’ll need to re-adjust your mirrors as there’s still a blind spot left.
Expert Q&A
- QuestionHow do I get rid of all my blind spots?
Simon MiyerovSimon Miyerov is the President and Driving Instructor for Drive Rite Academy, a driving academy based out of New York City. Simon has over 8 years of driving instruction experience. His mission is to ensure the safety of everyday drivers and continue to make New York a safer and efficient driving environment.
Driving InstructorEvery vehicle has blind spots, and different types of vehicles have different types of blind spots. You may be able to adjust your mirrors in a way where you minimize the size of your blind spots, but you aren't going to be able to get rid of them completely. - QuestionWhat if the view isn't the same in both side mirrors?
Community AnswerThis usually means one of the mirrors was not adjusted properly. When seated in a normal driving position, you shouldn't see your car at all in their side mirror. If only one side mirror shows your car, lean towards that side mirror and correct its alignment until you barely see the side of your car. - QuestionIs there any small mirror I can buy for my blind spot?Community AnswerBlindspot mirrors can be purchased online or perhaps motor factors/car shops. Between about £2 and £10.
Video
Tips
- Check your mirrors often, not only when changing lanes. Pairing this mirror setting method with frequent scanning will allow you to be more aware of vehicles and objects around you.Thanks
- Note that adjusting your mirrors this way means you have to turn your head to parallel park, as you can’t see your car in your side mirrors.Thanks
- It will take some time to adjust to driving with your mirrors arranged in this way. Give it about a week until you become comfortable.Thanks
Warnings
- Don't adjust mirrors while driving.Thanks
- Always look over your shoulders before changing lanes! While this mirror method eliminates blind spots for most vehicles, it is possible that motorcycles, bicycles and pedestrians won’t be as visible.Thanks
References
- ↑ http://pages.cs.wisc.edu/~gdguo/driving/BlindSpot.htm
- ↑ http://pages.cs.wisc.edu/~gdguo/driving/BlindSpot.htm
- ↑ http://pages.cs.wisc.edu/~gdguo/driving/BlindSpot.htm
- ↑ http://pages.cs.wisc.edu/~gdguo/driving/BlindSpot.htm
- ↑ http://www.caranddriver.com/features/how-to-adjust-your-mirrors-to-avoid-blind-spots
About This Article
To set your rear-view mirrors in order to eliminate blind spots, start by leaning your head to the left so that your head is almost touching the window. Then, adjust the driver’s side window so that you can see just the rear end of the car in the mirror. Next, lean to your right and adjust the passenger-side mirror so that you can see just the rear end of the car on that side, as well. Finally, return to your usual position and move the center mirror so that you can see directly out your rear window, and avoid tilting the mirror to get a better view of the traffic on either side. To learn more, like how to check the adjustment of your side mirrors from a normal, seated position, read on!
Reader Success Stories
"This confirmed what I saw on YouTube about adjusting mirrors in this manner. I have been driving for nearly 20 years with my mirrors adjusted improperly. I have a Camaro and it is a blind spot on wheels (so fun though) but this mirror trick helps."..." more
Did this article help you?
⚠️ Disclaimer:
Content from Wiki How English language website. Text is available under the Creative Commons Attribution-Share Alike License; additional terms may apply.
Wiki How does not encourage the violation of any laws, and cannot be responsible for any violations of such laws, should you link to this domain, or use, reproduce, or republish the information contained herein.
- - A few of these subjects are frequently censored by educational, governmental, corporate, parental and other filtering schemes.
- - Some articles may contain names, images, artworks or descriptions of events that some cultures restrict access to
- - Please note: Wiki How does not give you opinion about the law, or advice about medical. If you need specific advice (for example, medical, legal, financial or risk management), please seek a professional who is licensed or knowledgeable in that area.
- - Readers should not judge the importance of topics based on their coverage on Wiki How, nor think a topic is important just because it is the subject of a Wiki article.
