How to Repair a Scratched or Finger Printed Monitor Screen

Here is a simple way to fix a smudged or scratched monitor. It is necessary to have a clean display surface before attempting scratch repair.

Method 1

Method 1 of 3:

(Do not use tap water, as it can leave a deposit or streaks from the mineral content - use Deionized water instead!)
Advertisement

Method 2

Method 2 of 3:

Windex, Brasso, or any other solution which contains ammonia, or any other solvent including acetone, will damage ARAG (anti reflective , anti glare) coatings or films.
Never use abrasive solutions or solutions containing solvents on screens with ARAG coating/film.
Few CD/DVD repair fluids can be used to fill or smooth over small scratches or scrapes in the plastic-like first layer of anti glare films. This is because some fluids contain solvents and/or abrasives.
You can also use Pledge or some similar wood polish: It will fill in the scratches on computer monitors or CD's. However, it will leave discoloring blemishes, often more objectionable than a scratch. Petroleum jelly has the same effect, and is much harder to remove. Plastic model glue has irreversible negative effects.
Damaged ARAG films can be peeled off, and new ones applied. Operating without an ARAG film will reduce contrast, alter gamma, and therefore distort picture of display unless adjusted to compensate.

Method 3

Method 3 of 3:

This is irreversible, make sure you can buy replacement ARAG film.
Glass repair resins may be more effective for very deep scratches.
Make sure the new film is similar in properties to the original. Be sure to check your gray scale tracking and adjust the display as necessary to avoid color and luminance distortion due to varied transmittance of new coating.

Expert Q&A

Search

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

If you are performing this on a laptop, tip the screen back as far as it will go so water doesn't get on the keyboard.
Thanks
Helpful0 Not Helpful0
The best cloths to use are the soft golden colored ones with the zigzag edges.
Thanks
Helpful0 Not Helpful1
To determine whether your display has ARAG coating, check for purple colored reflections from the glass. Most anti reflective coatings reflect the high and low end of the visible light spectrum, reducing mainly the reflected light from the middle of the spectrum. Beware some displays have an anti static coating which can not be identified with this method.
Thanks
Helpful0 Not Helpful2