How to Remove Wallpaper Paste

Download Article

Explore this Article

parts

1Preparing to Wash the Walls

2Soaking and Wiping the Walls

Other Sections

Questions & Answers

Video

Tips and Warnings

Things You'll Need

Related Articles

References

Article Summary

Download Article

You've done the hard job of stripping the wallpaper from your walls, but there's still a big step to take before you can paint them. The sticky paste that was used to adhere the wallpaper to the walls is typically made from modified starch or methyl cellulose. If the paste is not removed prior to painting, the paint may flake, rub off or have an uneven appearance. Use these tips to remove wallpaper paste from walls.

Steps

Part 1

Part 1 of 2:

Preparing to Wash the Walls

Download Article

1. 
   1
   Protect your room so you can remove wallpaper paste from the walls. The job can get pretty messy, so it's a good idea to cover the floors and other parts of the room before you get started. If everything's already protected because you just stripped your wallpaper, all the better.

   • Tape off and cover outlets, switches, vents, baseboards and trim with painter's tape or plastic covers.
   • Cover floors with plastic or canvas tarps near all walls where you will be working. A disposable drop cloth is the best, as it will catch any loose scraps, and once you are done, you can just wrap it up and put to the garbage.
   • Remove or cover furniture with plastic tarps. If your room is large, move furniture to the center of the room while you work.
   • Turn off the electricity to the room to avoid any electrical mishaps.
2. 
   2
   Get your supplies ready. The process of removing wallpaper paste is as follows: soak the paste, rub the paste, then rinse the wall. That means you'll need several different items to do the job:

   • A bucket filled with wallpaper paste removal solution.
   • A sponge for soaking the paste.
   • A spray bottle filled with water.
   • A dry rag for wiping the wall clean (you'll probably need more than one of these to do the whole job).
   • A garbage can.
   Advertisement
3. 
   3
   Mix up your wallpaper paste removal solution. Hot water alone won't do the trick - you'll need a solution that softens the paste, making it easier to remove from the walls. There are a variety of solutions you can use for the job:

   • Hot water and a few squirts of dish soap. This works perfectly well on most wallpaper paste. Fill up a gallon-sized bucket with the solution.
   • Hot water and vinegar. This is great for tougher jobs. Mix a gallon of hot water and a gallon of white distilled vinegar.
   • Try adding 1 to 2 tablespoons (14.8 to 29.6 ml) of baking soda into the bucket. The baking soda helps to dissolve the wallpaper paste.
   • Trisodium phosphate, or TSP. TSP is an industrial-grade cleaner that was once widely used as a cleaner. Is it extremely strong, but not great for the environment, so try using when other, gentler methods have been exhausted.
   • For the heaviest jobs, you might want to buy wallpaper paste remover from the store. The commercial removers use chemicals to quickly dissolve the paste. Follow the directions to mix commercial wallpaper paste remover. It is available from most paint or hardware stores, and contains ingredients created specifically to dissolve wallpaper paste.
4. 
   4
   Put on some rubber gloves. Wallpaper paste can contain chemicals that aren't great for your hands. The job of removing it can take several hours, so it's a good idea to protect yourself by putting on a pair of long rubber gloves, the type you'd use when washing dishes.
Advertisement

Part 2

Part 2 of 2:

Soaking and Wiping the Walls

Download Article

1. 
   1
   Soften the wallpaper paste by soaking it. Dip the sponge into the wallpaper paste removal solution you mixed up. Apply the solution to the wall, soaking it entirely. Don't soak the entire wall at once; do a 5 x 5 foot section at a time, so it won't dry before you can get to it. Let the solution sit for a few moments so it has time to soften the paste.

   • If you don't want to use a sponge, you can use a spray bottle. Pour the solution into the bottle and spray a 5 x 5 foot area with the wallpaper paste remover. Wait 5 minutes for the paste to soften.
   • Adjust the spray nozzle so it does not squirt directly on the wall, but it sprays a fine mist. Gradual saturation is necessary when spraying the wall.
2. 
   2
   Rub off the wallpaper paste. Use the sponge to rub in a circular motion until the softened paste starts to come off. Discard it in the garbage can as you remove it.

   • Scrape the wallpaper paste with a putty knife if you have trouble getting it off with a sponge. Scrape using even motions that do not cause your putty knife to damage the drywall.
   • If the paste doesn't seem to be budging, soak it thoroughly and try again.
3. 
   3
   Repeat the process. Soften and scrape the wallpaper paste throughout the room until most of the wallpaper paste is gone. Do so methodically, section by section, so you're less likely to miss any one area.
4. 
   4
   Remove residual wallpaper paste. Soak any remaining wallpaper paste with more spray mixture, and scrub it with a tough scrubber. Forceful scrubbing may be required to remove it.
5. 
   5
   Spot clean remaining areas that were taped off or covered. Remove the tape and covers from vents, outlets, switches, baseboards and trim. Use a sponge and the spray remover to carefully treat small areas.
6. 
   6
   Allow the walls to dry for 12—24 hours. Run your hand along the walls. If they are smooth, most of the glue has been removed. If they feel sticky, repeat the process.
Advertisement

Community Q&A

Search

Add New Question

• Question

  I'm down to the drywall. Is there anything that I can put on the walls to cover up the flaws and make them smooth enough to paint?

  

  Community Answer

  Sure, use sheetrock compound. Fill all the holes, making the surface as smooth as you can. When totally dry, use a medium grit sandpaper over the wall. Be sure to wipe it down with a damp cloth to remove all the dust. When dry, apply two coats of latex primer. Then you are good to paint.

  Thanks! We're glad this was helpful.
  Thank you for your feedback.
  If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn

  YesNo

  Not Helpful 5Helpful 9
• Question

  Can I sand the walls to remove excess paste?

  

  Community Answer

  The short answer is "No." You really need to use the general process outlined above. First, get the old wallpaper off. Then, wash the walls with one of the mixtures noted above and rub down the wet walls with towels. I usually use a scraper first -- you will be amazed at the amount of old paste/glue you will get -- and then finish with a damp sponge. Sanding your walls could damage them or make them rough and unsightly.

  Thanks! We're glad this was helpful.
  Thank you for your feedback.
  If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn

  YesNo

  Not Helpful 5Helpful 9
• Question

  How do I remove heavy back wallpaper with a putty coating?

  

  Community Answer

  Using a wide putty knife blade, 4-6 inches wide, remove the wallpaper from underneath, sliding the knife upward. It's a lot of work, but it will come off. If the paper is not too layered, you could also soak the wallpaper first. It then will peel off easier. It's a mess, but the process does work.

  Thanks! We're glad this was helpful.
  Thank you for your feedback.
  If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn

  YesNo

  Not Helpful 5Helpful 9

See more answers

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Advertisement

Video

Tips

• If you're using a steamer to strip the paper simply go over the bare walls again once you've stripped the paper, and use the steamer to soften the same residual paste. Then scrape and wipe as described.
  Thanks

  Helpful2Not Helpful0
• Don't gouge drywall when attempting to remove stuck-on wallpaper paste. Use care when using the putty knife.
  Thanks

  Helpful10Not Helpful16
• Shake off the removed glue from your putty knife into a bucket. Allow the removed glue to dry and take it out with your trash for disposal.
  Thanks

  Helpful8Not Helpful12

Submit a Tip

All tip submissions are carefully reviewed before being published

Submit

Thanks for submitting a tip for review!

Advertisement

Things You'll Need

• Water
• Wallpaper paste remover solution (commercial or using vinegar or dish soap)
• Bucket
• Sponge
• Clean cloths
• Spray bottle
• Steel wool
• Putty knife
• Painter's tape
• Tarps