When & How to Prune Gardenias for Healthy, Happy Blooms

Download Article

A guide to perfectly pruning a gardenia bush

Download Article

• Deadheading
|
• Pruning
|
• Maintenance
|
• Q&A

|Show more|Show less

Gardenia bushes are a lovely addition to any garden, but if left alone they can get a little scraggly. Make sure you prune after your gardenias are finished blooming, and that you use sharp pruning shears. You should first remove any dead blooms, and then trim back shoots that alter the natural shape of the gardenia bush.

Things You Should Know

• Cut away half of the oldest branches at the trunk using pruning shears. Cutting the oldest, thickest branches will allow space for new growth.
• To encourage new growth, trim the remaining branches to your desired height and shape by making cuts above a stem branch or leaf node.
• Remove dead stems throughout the flowering season by pinching off the brown or black blooms at the seed base.

Steps

Part 1

Part 1 of 3:

Removing Dead Stems

Download Article

1. 
   1
   Pinch off dead stems with your fingers. Throughout its flowering season, regularly look over the plant for dead blooms – they’ll be brown or black and look generally unhealthy. With your thumb and index finger, pinch behind the swollen seed base that’s behind the base of the bloom. Pull the dead stem off the branch.

   • This practice is known as “deadheading.”
   • You may need to use hand pruners for thicker stems.
2. 
   2
   "Deadhead" your gardenia bush once a week during blooming season. Look for and pinch off dead or fading flowers once a week. Removing them regularly can encourage the growth of longer-lasting flowers, and can also increase the number of flowers that will bloom later.
   Advertisement
3. 
   3
   Time your pruning right. If you prune your gardenia bush with shears before it’s finished blooming, you could cause damage to the growing blooms. Instead, plan on pruning your gardenia bush after the blooming season is over, but before the daytime temperature falls below 65 °F (18 °C). You'll know it's time to prune the bush once see the flowers begin to fade. Prune the bush 1 or 2 weeks after the flowers fade.
Advertisement

Part 2

Part 2 of 3:

Pruning for Shape, Size, and Growth

Download Article

1. 
   1
   Use standard pruning shears when trimming gardenias. For branches that are up to 1.5 in (3.8 cm) thick, use common hand-held pruning shears. In the unlikely event that you have branches larger than that, use a narrow-bladed saw.
2. 
   2
   Disinfect your shears (and saw, if needed) before using them. Mix a solution of 1 part rubbing alcohol to 1 part water. Dip the blades into the solution, or apply it to a clean rag and wipe down the blades. However, if it's been awhile since you've used your shears, let the blades soak in the solution for 10 minutes or so. Then let your shears air dry.

   • You can also use a solution of 1 part bleach to 9 parts water.
   • Wipe down the blades after cutting any diseased or infected branches, and when moving from one plant to another.
   • If you don't disinfect your shears, you could accidentally transfer any insects or disease from one branch (or plant) to another.
3. 
   3
   Step back to determine the size and shape of your gardenia bush. Stand far enough away from your gardenia bush that you can see the whole thing in comparison to the area around it. Then decide what size and shape you'd like the bush to be. Once you begin pruning, step back frequently to check to make sure you're maintaining the size and shape you want.
4. 
   4
   Hold the pruning shears at a 45-degree angle to the branch. This angle will help you cut through the branches easily. It also prevents you from damaging the main branches of the bush if you get too close.
5. 
   5
   Cut away half of the oldest branches at the trunk. Cutting the oldest, thickest branches will allow space for new growth. Depending on how overgrown your gardenia bush is, you might want to trim out more than half of the oldest branches.

   • The oldest branches tend to be the darkest shade of brown and the thickest.
6. 
   6
   Trim the remaining branches down to your desired height and shape. After you've thinned out the oldest branches, trim the remaining branches. As you're trimming the branches, make sure you make cuts above a stem branch or leaf node to encourage new growth there.

   • The stem branch is where thinner stems branch off of thicker limbs. The leaf node is the bulge at the end of the leaf stem at the branch.
7. 
   7
   Prune most where you want to encourage growth. In addition to pruning your gardenia bush to maintain its shape and size, you can prune to encourage growth in certain areas. If you prune back the bottom of the gardenia bush beyond the excess growth – up to a few inches – that area will tend to grow back fuller.
Advertisement

Part 3

Part 3 of 3:

Maintaining Your Gardenia Bush

Download Article

1. 
   1
   Water your gardenias regularly. Regular watering will promote thick foliage and bloom growth. The soil around your gardenia bush should almost always be moist. How often you'll need to water your gardenia bush will depend on how dry the weather is.
2. 
   2
   Fertilize your gardenia bush 2 to 3 times per year. One of the best times to fertilize your gardenia bush is after you prune it. Use a fertilizer with a a 3-1-2 or 3-1-3 ratio of nitrogen, phosphorus, and potassium. Follow the instructions on the fertilizer packaging for the amount you should use, and mix it into the soil around your gardenia bush.
3. 
   3
   Check for bugs on your gardenias. You should look for mealybugs, caterpillars, aphids, whiteflies, thrips, and spider mites. If you see any of these insects on your gardenia bush, try a natural remedy to remove them. If the infestation is bad, you may need to use an insecticide.

   • To get rid of aphids, spray them with water every 2-3 days until they disappear.
   • For whiteflies and spider mites, try applying neem oil or insecticidal soap to your gardenia bush.
   • Use your hands to pick caterpillars off your gardenia bush
Advertisement

Community Q&A

Search

Add New Question

• Question

  Gardenia grafted on tree trunk has sticky white stuff on underside of leaves and trunk of tree. What could this be?

  

  Community Answer

  The sticky white powder is left behind by mealybugs. Mealybugs are little sap-feeding insects that grow waxy filaments as they mature. They often feed in clusters on tender branches,stalks, and the undersides of leaves, where they shed their body filaments onto plant tissues while they exude a sticky, sweet substance called honeydew.

  Thanks! We're glad this was helpful.
  Thank you for your feedback.
  If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn

  YesNo

  Not Helpful 0Helpful 1
• Question

  Half of my gardenia is dead and other half is a dull green. What can I do?

  

  Myra Preston

  Community Answer

  If your gardenia is wilting or dying, it is likely caused by a pest or disease and can be remedied by adjusting humidity levels and pruning the plant. This will help improve airflow while also limiting the spread of disease. Using an insecticide and fertilizing your plant can also help.

  Thanks! We're glad this was helpful.
  Thank you for your feedback.
  If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn

  YesNo

  Not Helpful 0Helpful 0
• Question

  My outside container gardenia was nearly killed over the winter. There are a few green leaves near the base of the plant. How far should I prune it & when?

  

  Myra Preston

  Community Answer

  Despite your best efforts, the tips of the branches may die and turn black from frost or cold damage. When this happens, prune the branches a couple of inches (5 cm.) below the damage with sharp pruning shears. If possible, wait until after it blooms.

  Thanks! We're glad this was helpful.
  Thank you for your feedback.
  If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn

  YesNo

  Not Helpful 0Helpful 1

See more answers

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Advertisement

Tips

Submit a Tip

All tip submissions are carefully reviewed before being published

Submit

Thanks for submitting a tip for review!