3 Quick and Easy Ways to Melt Hard Bean Wax

Download Article

A complete guide to using hard wax beans at home for silky smooth results

Download Article

Microwave

|

Stovetop (Double Boiler)

|

Wax Warmer

|

Q&A

|

Tips

|

Warnings

|

Things You'll Need

You’ve got your bag of colorful wax beans ready to go, but how exactly are you supposed to melt them down? Thankfully, you don’t need any fancy equipment to do a hard wax treatment at home. We’ll walk you through how to melt your wax down in the microwave, on the stove, or in a wax warmer—and most importantly, how to tell when it’s ready to go. In a matter of minutes, you’ll be one step closer to smooth, hair-free skin.

Things You Should Know

Microwave hard wax beans in 10-second increments using a microwave-safe bowl.
Create your own double-boiler setup by adding 1-2 in (2.5-5 cm) of water to a pot or saucepan and melting the wax beans in a heat-resistant bowl overtop.
Set your wax warmer to the highest possible heat to melt down all of the wax beans.
Check the consistency rather than the temperature of the melted wax to see if it’s ready to use.

Method 1

Method 1 of 3:

Microwave

Download Article

1
Pour the wax beans into a microwave-safe bowl. A heat-resistant glass mixing bowl is a safe bet—just make sure that it’s large enough so you don’t have to fill it more than halfway with hard wax beans.
- Check the bag instructions on your beans to see how many you need to melt. Ultimately, it’ll depend on how much skin you plan to wax.
After a quick round in the microwave, check the wax beans and see how much they’ve melted. Stir the beans with a wooden stick as they start to congeal so your wax has an even consistency.^{[1]XResearch source}
Advertisement
3
Microwave the wax repeatedly for 10 seconds until it looks like thick honey. Scoop up some of the wax and see how it looks on the wooden stick. It’s good to go if it’s pretty thick and honey-like.^{[2]XResearch source}
- Check the temperature of the wax by patch-testing it along the backside of your wrist. If it feels a little too warm, wait a few minutes before applying any wax.^{[3]XResearch source}
4
Reheat the wax in 10-second increments when it starts to congeal. While a microwave is the quickest way to melt hard wax beans, it doesn’t provide a lot of residual heat to keep them at the ideal temperature and consistency. Stick the wax in the microwave in 10-second increments until it is once again warm with a thick, honey-like consistency.
- Be sure to stir the wax with a wooden stick in between each microwave cycle.

Method 2

Method 2 of 3:

Stovetop (Double Boiler)

Download Article

1
Pour 1-2 in (2.5-5 cm) of water into a medium-sized pot. Add at least 1 in (2.5 cm) so the water doesn’t boil away completely, but don’t fill the pan more than halfway. With a double boiler, your goal is to create gentle, indirect heat.^{[4]XResearch source}
- A saucepan also works if you don’t have a pot on hand.^{[5]XResearch source}
Bring the water to a boil and reduce it to a simmer. Turn the stovetop burner up to high heat and wait for the water to bubble and boil. At that point, turn the heat down to a low temperature so the water settles to a simmer. Remember: with double boilers, the name of the game is gentle heat.^{[6]XResearch source}
3
Pour the hard wax beans into a stainless steel or tempered glass bowl. Grab a small- or medium-sized mixing bowl that’s heat resistant—stainless steel or tempered glass is a safe bet.^{[7]XResearch source}
- Check the instructions on the wax bean bag to see how much you should melt at once.
Center the mixing bowl so it rests along the edge of the pot while hovering slightly above the water. If the bottom of the bowl touches the water, the wax beans might get too hot.^{[8]XResearch source}
Stir the wax frequently with a wooden stick.^{[9]XResearch source} Grab a clean stick and give the melting beans a good stir every minute or 2. This helps give your wax a more even consistency since the indirect heat of the double boiler prevents the beans from melting evenly.
6
Do the “flip” test to see if your wax is ready. Scoop up a large dollop of melted wax with a wooden stick and flip it over in front of you, watching the wax slowly collect and fall away from the base of the stick. If you can count to 2 or 3 before the wax completely drips off the stick, your wax is ready to use. Then, quickly flip the stick back over before the wax can actually separate and fall off.^{[10]XResearch source}
- The wax is much too hot to apply if it immediately falls and separates from the stick. If it takes more than 3-4 seconds to drop away, the wax is too cool to apply.^{[11]XResearch source} Depending on the consistency, either raise the temperature slightly or give your wax some time cool off so it’s safe to apply to your skin.

Method 3

Method 3 of 3:

Wax Warmer

Download Article

1
Pour the wax beans into the warming chamber. Simply open the lid on your wax warmer and pour the beans into the inner compartment.^{[12]XResearch source} Many warmers have a fill line marked on the inner chamber—don't add beans beyond this line. If there isn't a fill line, don't fill the chamber more than two-thirds full.
- Double-check your wax warmer’s user manual to see what the manufacturer recommends.
2
Set the warmer to the highest possible setting for 10-15 minutes. As the wax starts to melt, use a wooden stick to mix the melted wax along the edge of the chamber with the less-melted wax at the center. In about 10-15 minutes, all of the wax will be melted.^{[13]XResearch source}
- To be safe, consult your wax warmer’s manual to see if the manufacturer mentions any specific temperature suggestions.
3
Check the wax with a wooden stick to see if it resembles molasses. Dip a wooden stick into the melted wax and scoop up a dollop of it. Then, hold out the wooden stick and watch how quickly (or slowly!) the melted wax drops from the bottom of the stick—just be sure to flip the stick over before it actually does. If you can count to 2 or 3 before the wax falls off, your wax is safe and ready to use for waxing.^{[14]XResearch source}
- Liquid-like wax is far too hot to wax your skin with, while super slow wax is too cool.^{[15]XResearch source} Adjust the temperature on your warmer accordingly until the wax looks like molasses or thick honey.

Community Q&A

Search

Add New Question

Question
Do I melt just enough wax for one application (upper lip), or can it be reused and reheated? I am the only one who uses it.
Ester
Community Answer
Hard wax is the only kind of wax that salons can re-use. Because hard wax must be applied in a thick layer and is typically applied at least twice in order to remove all the hair, certain salons re-use it to save money. They melt the wax, strain out the hair, let the wax harden again and then melt it for re-use.
Thanks! We're glad this was helpful.
Thank you for your feedback.
If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn
Yes No
Not Helpful 25 Helpful 9

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Tips

Make sure that your hair is between ¹⁄₄ and ³⁄₄ in (0.64 and 1.91 cm) long before you start waxing.^{[16]XTrustworthy SourceAmerican Academy of DermatologyProfessional organization made of over 20,000 certified dermatologistsGo to source}
Thanks
Helpful0 Not Helpful0
Check the instructions on your wax package to see if it needs to be applied at a specific temperature.
Thanks
Helpful0 Not Helpful0

Submit a Tip

All tip submissions are carefully reviewed before being published

Submit

Thanks for submitting a tip for review!

Warnings

Stop using any OTC or prescription retinol creams for 2-5 days if you plan on waxing your eyebrows or upper lip hair. This way, you won’t accidentally remove any skin while you wax.^{[17]XTrustworthy SourceAmerican Academy of DermatologyProfessional organization made of over 20,000 certified dermatologistsGo to source}
Thanks
Helpful1 Not Helpful0