How to Make a Flower Press

Pressed flowers can be a beautiful addition to scrapbook pages or handmade cards. You can press flowers between the pages of a book, but stacks of books can be cumbersome and flowers are disturbed each time you add new ones. Instead, try making your own flower press out of wood, bolts, and cardboard to create beautiful pressed flowers you can enjoy for years to come.

Part 1

Part 1 of 4:

Fashioning the Press Covers

Download Article

1
Cut 2 wood squares in the size you want for your press. Cut the wood with a table saw or a circular saw. You can make your press any size you want it to be, depending on the size of the plants you’ll be pressing. Between 8–12 inches (20–30 cm) should be big enough for most projects.^{[1]XResearch source}
- For best results, choose wood that is ³⁄₄ inch (1.9 cm) or 1 inch (2.5 cm) thick.
- Visit your local hardware store and ask the employees to cut the wood for you if you don’t want to use a saw. Most hardware stores will perform this service for free.
Mark the spot with an X using a pencil. This will be the location for your drill holes.
Advertisement
3
Drill a hole through each of the marks. To ensure your boards will line up perfectly, drill through both of them at the same time. If you’re using ¹⁄₄ inch (6.4 mm) bolts, use a ⁵⁄₁₆ inch (7.9 mm) drill bit.
- If you’re using a different bolt and you’re not sure what size drill bit to use, pick a bit you think is about the same size, then drill a test hole through a piece of scrap wood and make sure your bolt slides through easily. Adjust the size as needed.
Sand the surface of the wood. Use a medium-grit sandpaper or a sanding tool if you have one. Make sure the wood is smooth, especially around the holes you drilled.
5
Stain or paint the wood if you want. You can personalize your flower press by staining or painting it any color you want. You can also leave the wood plain if you prefer.^{[2]XResearch source}
- If you do use a paint or stain, allow the wood to dry completely before moving to the next step.
- Try decorating your press with stencils or cut-out illustrations of flowers.

Part 2

Part 2 of 4:

Assembling the Flower Press

Download Article

The cardboard and paper should be slightly smaller than your press.
2
Cut the edges of your cardboard and paper off. Once the cardboard and paper are cut to size, cut away the corners so the paper and cardboard will sit inside the bolt holes. You should cut off a triangle-sized piece from each corner. When you're finished, the paper and cardboard should look like a square with the edges cut off.
- The paper absorbs moisture from the flowers during pressing. You can use any kind of smooth paper, including newsprint, blotting paper, tissue paper, or smooth coffee filters. Avoid paper towels or other textured paper because it may leave an imprint on the petals.^{[3]XResearch source}
Slide the bolts through the 4 holes on the first piece of board, then place the board on your work surface. The head of the bolts should be facing down.
You’ll add 1 piece of cardboard first, followed by the 2 pieces of paper. Top that with the last piece of cardboard.
5
Add another layer of cardboard and paper if you want. You can add as many layers as will fit on your press. Just cut 2 more pieces of cardboard and 2 more pieces of paper and add them on top of the first layer.
- Even if you only make 1 layer at first, you can still go back and add another layer any time after you make your press.
Once you have added all the layers of cardboard and paper, slide the last board onto the bolts.
7
Place the washers and wingnuts on the bolts and tighten them. You’ll put down the washers first, then the nuts. Tighten the nut just until it feels secure. You don’t want to tighten them too much, as you’ll need to raise and lower the nuts in order to add flowers to your press.^{[4]XResearch source}
- Wingnuts are designed to be gripped and can be tightened and loosened more easily than traditional nuts, but if you only have regular nuts on hand, you can use those.

Part 3

Part 3 of 4:

Choosing Flowers to Press

Download Article

The best time to pick your flowers is in the morning after the dew has evaporated. This is when they will be the most fresh.^{[5]XResearch source}
Pressed flower buds are lovely, as are flowers which are fully bloomed. Try to pick flowers in a variety of stages for a natural look.^{[6]XResearch source}
3
Select flowers with naturally flat blooms, like violets and daisies. Other flowers that press well include single-petal roses, Cosmos, California poppy, and Queen Anne’s Lace.^{[7]XResearch source}
- Flowers with bulky blooms, like roses or carnations, take much longer to dry and don’t look as nice when they're pressed. You may want to hang them to dry them instead.
Some flowers, like lilies, have stamens which protrude from the petals. Remove these before you press the flower or the stamen will leave a stain on the dried petals.^{[8]XResearch source}
If you're going to display your flowers in a frame, you can add other natural touches by drying leaves, grasses, herbs, and ferns in your press.^{[9]XResearch source}

Part 4

Part 4 of 4:

Pressing Your Flowers

Download Article

You don’t have to take the nuts all the way off, just loosen them enough that you can slide the flower into the press.
Make sure the flowers are not hanging off of the side of the press. Trim the stem or choose another flower if the one you chose doesn't fit on the press.
Arrange the flowers on the paper so they are not touching each other, or else they’ll be stuck together when they’re dry.^{[10]XResearch source}
There's no need to force the nuts tighter than you can comfortably tighten them, but it should feel like it's secured. You may want to check the press every few days to tighten it more as the flower dries.
You want to allow the moisture in the plants to completely dry in order to preserve them.
If you find more flowers that you want to press while you’re drying the first batch, add the new flowers to a different layer of cardboard and paper, and take care not to disturb the first set.
7
Store the flowers in a box or display them in a frame after they're pressed. Pressed flowers are very fragile, so you'll want to keep them in a safe place once they're finished drying. Store them in a box until you need them.
- Use pressed petals to decorate homemade cards, as a pretty touch in a handmade candle, or as decorative touches in a shadow box.

Community Q&A

Search

Add New Question

Question
I'm trying to press a clover and a flower into my diary. How do I go about doing it?
Community Answer
First press the clover and flower in different books. When they are completely done, you can put them in your journal.
Thanks! We're glad this was helpful.
Thank you for your feedback.
If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn
Yes No
Not Helpful 5 Helpful 12
Question
I have pressed wild flowers. How do I put them on the wall without frames or make my own wallpaper on painted paneling?
T. Chinsen
Top Answerer
Look for a glue that seals, dries clear and is preferably waterproof when dry. Glues can change the color of the dried flowers, and most general purpose glues and varnishes will yellow with age. Ask for help in the glue section of a craft store to find the best product for you needs.
Thanks! We're glad this was helpful.
Thank you for your feedback.
If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn
Yes No
Not Helpful 1 Helpful 7
Question
How do you maintain even pressure? Doesn't the centre bow this way?
Nicholas Slater
Community Answer
If you use thick enough wood, then it won't bow in the middle. You could always add a thin piece of wood in the middle as support.
Thanks! We're glad this was helpful.
Thank you for your feedback.
If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn
Yes No
Not Helpful 0 Helpful 5