How to Make a Fake Arm Cast

A fake arm cast can be useful in a number of situations. Maybe you want to play a prank on your friend, or maybe you need a cast for a costume. You can use a simple method, such as making a cast out of toilet paper, or a more complicated method, such as sewing a reusable cast on a sewing machine, to make a fake arm cast.

Method 1

Method 1 of 3:

Make a Fake Arm Cast Using Toilet Paper

Download Article

1
Use a washable marker to mark the cast lines. Decide how far you want your cast to come down you arm.
- For this type of cast, it's best to not go past the elbow.
- This type of cast will look more like an older plaster-type cast rather than the fiberglass wrapped cast most often used today.^{[1]XResearch source}
2
Wrap two layers of toilet paper around the bottom part of your arm. Starting just below the marker line, begin wrapping the toilet paper around your arm in two layers. Tear off the paper.
- At this point, don't cover your hand. Focus on the part of your arm below the wrist.
Advertisement
Hold your arm under water for a few seconds, wetting the paper thoroughly.
4
Squeeze out the water. Press the paper to your skin, squeezing out the water as you go.
- It's acceptable to have a few wrinkles or tears. You're going to be covering that layer in more toilet paper.
Wrap it around the same part of your arm.
Hold your arm under the water for a few seconds to wet the toilet paper.
Press out the water, pushing the paper in towards your arm.
Continue adding paper until you have a thick layer of toilet paper on the bottom of your arm.
Connecting it to the rest of the cast, wrap the paper around your hand, going above and below your thumb.
Add layers, wetting them as you go. Be sure to press the paper down to your arm so the excess water is squeezed out.
11
Let the cast dry. You can rest your arm on a towel or pillow to allow the cast to dry.
- Alternatively, try using a hair dryer.^{[2]XResearch source}

Method 2

Method 2 of 3:

Creating a Cast Using a Sock, Gauze, and Duct Tape

Download Article

1
Use a white sock. Cut the ankle out of the sock. Cut a small triangle off at the ankle, leaving it attached on the top side.^{[3]XResearch source}
- If the sock is long enough, you can cut off the foot all together. Basically, you want to create on log tube that will fit over your arm. By cutting off just the heel, you create a tube that lays flat on your arm.
- Use a sock that you don't care about, as you will be damaging it beyond repair.
Snip off the end of the sock at the toes so you have an even toe.^{[4]XResearch source}
3
Cut a hole for the thumb. Leaving about two inches or so at the bottom of the tube, cut out a small section to fit your thumb through.
- Using sharp scissors, cut a half circle in the folded sock, creating a hole for your thumb.
Pull the sock up as far as you want the cast to come up your arm. If it's too long, cut off part of the sock to make it shorter. However, you want to leave some to fold over the end of the gauze.
5
Wrap your arm with self-adhesive gauze. Starting at the bottom, wrap you arm in the gauze. Leave some space at the bottom of the sock to fold over the gauze. Overlap each layer. When you reach your hand, wrap over and under your thumb, leaving your fingers free.^{[5]XResearch source}
- Don't wrap it too tightly, as it will cut off circulation.
6
Fold the sock back over the gauze. Fold the ends of the sock over the gauze.
- This step isn't vital, but it will make the ends look neater.
7
Use colored tape to wrap your arm. Starting at the folded over edge of the sock at the bottom, wrap colored tape around your arm, overlapping as you go. You can use masking tape or duct tape.
- Make sure not to wrap it too tightly. You don't want to cut off the circulation.
- Work in smaller pieces to make it easier. Use about a foot of duct tape at a time so it doesn't fold back on itself.
- You can use sports pre-wrap in place of the tape.
If the edge of the duct tape overlaps near your thumb too much, carefully cut off the edges.

Method 3

Method 3 of 3:

Making a Fake Cast with a Sewing Machine

Download Article

Start where you want the cast to begin at the bottom of you arm and measure up to the top of your palm. Write down the number.
2
Measure the circumference of your arm. Wrap a measuring tape around the thickest part of your arm. Write down the number. Wrap a measuring tap around your hand just under the thumb. Write down the number.
- Add 2 inches to each of these measurements for overlap.
3
Measure two pieces of flannel. Use the length and the circumference measurements to measure out a piece of flannel.
- Angle down each side from the larger circumference measurement to the smaller one.
Also cut out cotton batting for the middle in the same size.
5
Check to make sure that the cast fits around your arm. Place one piece of the flannel around your arm. Make sure it overlaps an inch on each side at the thickest part.
- The part at the top of your hand will have a whole for your thumb eventually.
Use an old pair of tights. You can use colored tights or white tights, depending on your preference.^{[6]XResearch source}
7
Layer the pieces together. Put a piece of flannel on the bottom, the batting in the middle, and a piece of flannel on top. Lay out the strips of tights on top.
- The strips of flannel should overlap each other and zigzag across the cast. They should also run width-wise not length-wise.
8
Sew the strips on. Run along the edges of the strips to sew them on. You can use a plain stitch or a zigzag strip.
- You can use the same color for the thread as the tights or use a contrasting color.
Fold the cast in half length-wise. About an inch from the top, cut a round hole big enough for your thumb with small scissors.
Using a zigzag stitch, run around the edges of the cast and around the thumb hole.
On the two long sides, sew on matching Velcro strips.
Velcro it in place.

Community Q&A

Search

Add New Question

Question
What should I do if someone wants to sign it?
Community Answer
Tell them that it hurts for anyone to touch it, or that the doctor (or your parent) told you not to let anyone sign it.
Thanks! We're glad this was helpful.
Thank you for your feedback.
If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn
Yes No
Not Helpful 27 Helpful 84
Question
Can you give me simpler instructions on how to make a cast?
Community Answer
Grab a sock, cut off the toe, and wrap it in gauze and bandage wrap. You may want to put cardboard on the bottom or sides first to make it look more realistic.
Thanks! We're glad this was helpful.
Thank you for your feedback.
If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn
Yes No
Not Helpful 14 Helpful 50
Question
How do I make a leg cast?
Community Answer
You can use the same method, but you will also need to borrow crutches from a friend or family member.
Thanks! We're glad this was helpful.
Thank you for your feedback.
If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn
Yes No
Not Helpful 16 Helpful 77

See more answers

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Video

Tips

Tips from our Readers

The advice in this section is based on the lived experiences of How.com.vn readers like you. If you have a helpful tip you’d like to share on How.com.vn, please submit it in the field below.

Be sure not to use this trick to get out of school, gym, etc; you can get in trouble if caught!
You could also use paper towels or cut a piece off an old white blanket.

Submit a Tip

All tip submissions are carefully reviewed before being published

Submit

Thanks for submitting a tip for review!