How to Make a Car Spin

Download Article

Though this is a dangerous maneuver, you may want to make your car spin at some point.

Method 1

Method 1 of 4:

Front Wheel Drive

Download Article

On dirt you want to go about half that, preferably in 2nd gear with full throttle.
On an automatic transmission lightly touch the brake with your left foot, while keeping the right foot over the throttle.
Advertisement
^{[1]XResearch source}
Hold the safety button with your thumb at the same time. Continue steering until your steering wheel is locked. This is much easier on cars equipped with power steering, as you have to steer using only one hand.
This is perceived as a moment of weightlessness.
If you release the handbrake first, your car will stop spinning and start turning normally, possibly hitting the curb or driving off the road!

Method 2

Method 2 of 4:

High Powered Rear Wheel Drive

Download Article

^{[2]XResearch source}
This should result in a wheelspin and a tail-happy behavior of your car.^{[3]XResearch source}
Release the clutch and straighten the steering wheel at the same time.

Method 3

Method 3 of 4:

Low Powered Rear Wheel Drive or All Wheel Drive

Download Article

Continue until you feel the car can't take any more speed without losing control. You must be going in a perfect circle, without any under-steer (i.e. tendency of the front wheels to keep moving straight rather than turning).
Make a wheel spin as described above.
Release the clutch and straighten the steering wheel at the same time.

Method 4

Method 4 of 4:

Choosing the Perfect Car Parts

Download Article

The following section describes an idealized drifting car. A car set up for drifting is easily spun in place. Note that if you set up your car in the way described it will most likely be too unstable to be safely driven on public roads!

1
Install the following parts for the ideal drifting car.^{[4]XResearch source}
- Lowered and hardened suspension (sport springs, sports shocks) never cut springs!
- Rear camber set to full positive
- Front camber set to full negative
- Brake bias set to neutral (front and rear axle brake at the same time with the same force). In passenger cars and light cargo vans the brake bias is set to front with the purpose of avoiding a drift during in-turn braking
- Handbrake actuator cable with no slack
- High engine power (over 100 hp). Gasoline engine (diesels are slow and clumsy)
- No ECU (Electronic Control Unit,). The absence of an ECU excludes such control aids as the ESP or traction control. You cannot drift a car with any of them
- Rear wheel drive
- Manual transmission
- LSD (Limited Slip Differential) or any other automatically locking differential
- No ABS
- Power steering (for beginners; pros use direct steering for better control and feedback)
- Worn out narrow tires in the back and wide new tires in front
- Disc brakes on the rear wheels (drum brakes tend to slip and overheat more easily)
- Long wheelbase. With LWB cars you get better control during the drift/spin

Community Q&A

Search

Add New Question

Question
How do I jump out of a car while it's spinning?
Community Answer
You need special tools to lock your accelerator and steering wheel after you execute the spin. Then you simply jump out of the car.
Thanks! We're glad this was helpful.
Thank you for your feedback.
If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn
Yes No
Not Helpful 3 Helpful 18
Question
How do I spin the tires while a car is stopping?
Community Answer
First start your car, then press clutch. Shift to first gear and give half accelerator. Then remove your clutch suddenly and press full accelerator. At this point, the wheel starts spinning.
Thanks! We're glad this was helpful.
Thank you for your feedback.
If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn
Yes No
Not Helpful 7 Helpful 26
Question
Is there any need for hand brakes when I spin?
Community Answer
In FWD (and 4WD/AWD or low-power RWD), yes. You want to lock them so that only your front wheels would spin. Usually handbrakes lock the rear wheels (at least in FWD) and the power brake pedal in a modern car usually has ABS which doesn't let the wheels lock (therefore drum brakes are used there). In FWD and 4WD/AWD, the front wheels are powered so if they were locked as well, the engine would stall. In RWD, though, if you try to do the same, you'd stall the engine and spoil all the fun as no spinning would occur. You want the rear wheels to spin much faster than the front wheels in that condition.
Thanks! We're glad this was helpful.
Thank you for your feedback.
If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn
Yes No
Not Helpful 3 Helpful 7

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Tips

Don't do this if there are cops around.
Thanks
Helpful1 Not Helpful0
Don't go in reverse and turn sharply in any small car as they can roll!
Thanks
Helpful0 Not Helpful0
If you pull the handbrake hard for extended lengths of time, the locking of the car's wheels can cause a flat spot on the tire.
Thanks
Helpful0 Not Helpful0

Show More Tips

Submit a Tip

All tip submissions are carefully reviewed before being published

Submit

Thanks for submitting a tip for review!

Warnings

This is fun, but use moderation; spinning your car a lot can result in damage to your drive-train and tires. If you spin into anything, especially a curb, the damage is likely to disable your car. Frame damage is frequently impossible to repair.
Thanks
Helpful21 Not Helpful3
Avoid public roads - you could wreck your car and injure or kill yourself as well as others. Only do this in a secluded off-road area.
Thanks
Helpful22 Not Helpful5
Do not do this in an SUV, van or truck. Your vehicle will probably flip. This is because it could be top heavy. Most are. It would be safest in a car with lowered suspension. Don't forget: under certain conditions (rough surfaces, tire failure, high speeds), just about any car will flip.
Thanks
Helpful19 Not Helpful5
You should avoid doing it on dry asphalt as it strains your center differential. Try snow or dirt instead.
Thanks
Helpful15 Not Helpful6