How to Get Water Stains Off Wood

Whether someone forgot to put a coaster down or you accidentally spilled a glass, water can create unsightly stains on wood floors and furniture. Luckily, there are a few pretty easy steps that you can take to lift water stains out of wood without using any abrasive chemicals or cleaning supplies. Start by trying to iron the stain out of your wood. If that doesn’t work, soak the stain in mayonnaise or scrub it with toothpaste. If these methods aren’t successful, you may need to use an abrasive material like sandpaper or steel wool to scrape the stain away by removing a layer of wood.

Method 1

Method 1 of 4:

Ironing Stains out of Wood

Download Article

1
Drain all water out of your iron. Open the water cap on your iron by popping the top or twisting it counterclockwise until it’s all the way off. Take your iron to a sink and turn it over to empty out any water in the tank. Water is bad for wood and can cause it to rot, so you need to get all of the moisture out of your iron before you start.^{[1]XResearch source}
- If you can access the inside of the tank, wipe it down with a dry paper towel or cloth before reassembling it and putting it back into your iron.
- The sooner you can do this after the wood has been stained, the easier it will be to remove the stain.
- This method should be fine for any kind of wood. You can use a hair dryer instead if you don’t have an iron, but it will take much longer.
Tip: The iron will heat the moisture that is trapped inside of the wood and cause it to evaporate from inside the wood. This method won’t work if the stain is from anything other than water.
Lay an iron on the base and stand the plate up. Turn the dial on the iron to low and plug it in. Wait 5-10 minutes to let it preheat.^{[2]XResearch source}
Advertisement
You can use a shirt, cloth, towel, or rag. The thickness of the cotton will determine how long it takes to iron the stain out, but as long as it’s made of cotton, it doesn’t necessarily matter in terms of how effective it is.
4
Apply the iron to the cotton and iron in a circular pattern. Once your iron is preheated, lay the plate flat on your cotton over the stained area. Begin to slowly move the iron around the stain in a circular pattern. Make sure that you iron at least 4–8 in (10–20 cm) around the stain in every direction. Iron for 3-4 minutes.^{[3]XResearch source}
- Don’t let the iron just sit on one spot for more than 20-30 seconds or you’ll risk burning or warping the wood.
Grab the cotton by an unheated edge to avoid burning your hand. Pull the cotton up and inspect the stain to see if it is still there. If the stain is completely gone, you’re done.^{[4]XResearch source}
6
Repeat the process using the same cotton and iron to remove the stain. Use the same piece of cotton and the same iron on the same temperature to continue ironing the stain. Iron for another 4-6 minutes and repeat the process until the stain is gone.^{[5]XResearch source}
- This process could take up to 30 minutes depending on how old the stain is.

Method 2

Method 2 of 4:

Soaking the Surface in Mayonnaise

Download Article

1
Scoop 1-2 tablespoons (15-30 grams) of mayonnaise into a clean towel and rub it into the cloth. Get a clean, cotton towel or dish rag and scoop some mayonnaise into the center. Hold the edges of the towel so that the mayo sits at the bottom of the towel and rub it into the fabric with your free hand from the other side.^{[6]XResearch source}
- Mayonnaise contains eggs, oil, vinegar, and lemon juice. Most of these ingredients are included in furniture polishes and lacquers because they’re good at penetrating wood. The fat in the mayonnaise will absorb the moisture and leave your wood looking clean!
- If you don’t have access to mayonnaise, you can use petroleum jelly instead. Petroleum jelly may leave a weird texture behind after you clean it up though.
- Mayonnaise should be fine on any kind of wood. It may leave it smelling a little strange afterwards though.
Unfold your towel and place the center over the stain. Rub the mayonnaise directly into the stained area using firm, circular strokes. Rub the wood and make sure that you cover each area of the stain.^{[7]XResearch source}
Tip: You won’t damage the wood by rubbing firmly, so don’t worry about hurting your wood.
3
Let the mayonnaise soak into the stain for at least 1 hour. Lift your towel up without wiping the mayonnaise away and throw it in the washer or sink to clean it. One hour is the minimum amount of time that you should leave the mayonnaise on the wood. If you want maximum penetration into the wood or the stain is particularly old, leave the mayonnaise on the surface to let it soak overnight.^{[8]XResearch source}
- The smell might be kind of funky if you leave the mayonnaise on overnight, but you won’t be damaging the wood.
4
Wipe the mayonnaise up and inspect the stain to see if it’s gone. Get a clean cloth or rag and wipe up the mayonnaise. Check the stain to see if it is still there.^{[9]XResearch source}
- You can use a damp cloth to wipe up any dried mayonnaise. Just make sure that you wipe the water and moisture off after you do this.
5
Apply another layer of mayonnaise if the stain isn’t gone. If the stain is only partially gone, apply another layer of mayonnaise and repeat the process. If it isn’t coming out of the wood, try using a different method to get the stain up.^{[10]XResearch source}
- You may need to do this a few times to get the stain completely out.

Method 3

Method 3 of 4:

Brushing Dark Stains with Toothpaste

Download Article

1
Get a non-gel and non-whitening toothpaste and a clean toothbrush. Gel toothpastes tend to be thinner and weaker, so they may not do as good a job at penetrating the wood. Whitening agents contain chemicals and additives that may not help you clean your stain. Use a clean toothbrush to clean water stains from wood.^{[11]XResearch source}
- This method works best if the stain is dark and your wood is lighter. Do not use toothpaste on antique wood.
- If you’re worried about damaging the grain of your wood, use a soft cloth instead of toothpaste.
Tip: This is not the best option if your wood is antique, since the bristles on the brush could change the grain in older wood.
Load your toothbrush with toothpaste and start to scrub your stain using back-and-forth strokes. Work in the direction of the grain to effectively clean your wood. Brush each section at least 5-6 times to ensure that the toothpaste gets into the wood.^{[12]XResearch source}
3
Let the toothpaste rest for 10-15 minutes and wipe it off. You don’t need to leave it on overnight or anything, but you do need to let the toothpaste sit for a couple of minutes after you’re done scrubbing. Wipe the toothpaste up with a dry paper towel.^{[13]XResearch source}
- If you leave the toothpaste on for too long, you could discolor the wood.
4
Polish the wood with a clear wood polish and soft cloth. After you’ve removed the toothpaste, check to see if the stain is gone. If it is, reseal your wood by using a wood polish. Spray some polish into a clean cloth and rub it into the wood. Wipe in the direction of the grain and let it air dry for 24 hours before you put anything on the wood.^{[14]XResearch source}
- Follow the manufacturer’s directions by reading the label on your wood polish before applying it. Some polishes have specific directions that you need to follow.
- Use a clear polish so that you don’t change the color of your wood.

Method 4

Method 4 of 4:

Using Abrasive Materials

Download Article

1
Scrape stains on finished wood away with extra-fine steel wool. Dip some steel wool in mineral oil. Scrape the stain in the direction of the wood grain. Go lightly at first to avoid ripping the wood up and try to only use the amount of pressure necessary to lift the stain out of the wood. Wipe excess oil off of the wood after the stain has disappeared by running a paper towel over the surface.^{[15]XResearch source}
- It’s not a good idea to use abrasives on antique wood if you care about the value.
Warning: This actually removes the finish from your wood. If you used a colored stain or lacquer to originally protect your wood, you may need to reapply it to keep the wood’s color consistent.
2
Strip layers off of unfinished wood with sandpaper. If the wood isn’t polished, finished, or stained, you can simply remove layers of your wood until the stained layers are gone. Start with a sheet of 120 grit sandpaper before stepping up to something coarser. Scrape the entire layer of the wood’s surface using back-and-forth strokes until the entire layer is gone. Wipe up wood shavings and dust with a dry cloth.^{[16]XResearch source}
- You can use a belt sander if you want to remove stains from a larger surface and keep the pattern uniform.
- This will change the style and pattern of your grain.
3
Use paint remover to get stains off of oak furniture. If your furniture is pure oak, you can use paint remover to lift it up. Put on some rubber gloves and fill a small cup or paint tray with paint remover. Dip a clean, natural brush in the paint remover and apply it to the stain by using back-and-forth strokes. Work in the direction of the grain. Use a clean rag to wipe it up after you’ve let it soak for 4-5 minutes.
- Try to avoid getting paint remover on the unstained areas of your wood. It may cause some discoloration if your wood is stained.^{[17]XResearch source}
- To stiffen the paint remover, you can make a 1-part paint remover and 1-part 5% bleach combination. Apply the solution in the exact same way to remove your water stain.

Community Q&A

Search

Add New Question

Question
How do i remove white spots by mopping
How.com.vn Staff Editor
Staff Answer
This answer was written by one of our trained team of researchers who validated it for accuracy and comprehensiveness.
How.com.vn Staff Editor
Staff Answer
White spots tend to come out with an iron or hair dryer. You really can't remove water stains by mopping with more water. If your stains are on the floor, reseal your floor after using heat to get the stains out.
Thanks! We're glad this was helpful.
Thank you for your feedback.
If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn
Yes No
Not Helpful 0 Helpful 1
Question
How do I remove water stains on a redwood indoor spa?
How.com.vn Staff Editor
Staff Answer
This answer was written by one of our trained team of researchers who validated it for accuracy and comprehensiveness.
How.com.vn Staff Editor
Staff Answer
Try using a powder dish detergent and scrubbing the wood with a soft-bristled brush and then reseal the wood. If this doesn't work, try letting your spa air dry over the course the course of the week.
Thanks! We're glad this was helpful.
Thank you for your feedback.
If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn
Yes No
Not Helpful 1 Helpful 1
Question
I am a new owner of a beautiful wood floor. It seems the former owner placed a plant on the floor that linked and placed a white water spot on the floor. I tried furniture polish, then toothpaste. What else can I do?
How.com.vn Staff Editor
Staff Answer
This answer was written by one of our trained team of researchers who validated it for accuracy and comprehensiveness.
How.com.vn Staff Editor
Staff Answer
Since the water was probably mixed with soil and organic matter, toothpaste won't get the stain out. Try using a mild dish soap to scrub the organic matter and soil stains up. You may notice you don't actually have a water stain underneath it. If you do, try using an iron and cotton cloth to evaporate the water trapped in the wood.
Thanks! We're glad this was helpful.
Thank you for your feedback.
If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn
Yes No
Not Helpful 0 Helpful 4

See more answers

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Tips

Submit a Tip

All tip submissions are carefully reviewed before being published

Submit

Thanks for submitting a tip for review!

Warnings

The above methods can be used for all types of wood including teak. But you should try out the method in an inconspicuous area before trying it on a visible surface.
Thanks
Helpful0 Not Helpful0
If the stain is on a piece of antique furniture, consult with an antiques expert before trying to get water stains out. Refinishing or damaging an antique can radically diminish its value.
Thanks
Helpful0 Not Helpful0