Tips for Trimming Long Hair Evenly (Your Own or Someone Else’s)

Download Article

Grab your scissors! It’s time to give yourself or a buddy a neat and clean new ‘do

Download Article

• Cutting Your Own Hair
|
• Cutting Someone Else's Hair
|
• Video
|
• Expert Q&A
|
• Tips
|
• Things You'll Need

|Show more|Show less

Cutting long hair straight is simple, but there are a few bad habits that can create gradations and prevent that neat, blunt, straight-across cut. Whether you’re cutting your own hair or somebody else’s, there are a few valuable tips and tricks to keep in mind—especially if it’s your first time! Keep reading to find out how to give yourself or a buddy a stellar straight-across ‘do!

Things You Should Know

• Before cutting your own hair, pull your hair in a low ponytail, tying the hair tie just above where you want to cut your hair. Use sharp hairdressing scissors to cut your hair.
• To make sure your hair is cut perfectly straight, divide your hair into 2 or 4 even ponytails, and lay them in front of your shoulders. Cut them at a slight angle.
• When cutting someone else’s hair, start with the bottom layer. Cut their hair layer by layer to be as exact and precise as possible.

Steps

Method 1

Method 1 of 2:

Cutting Your Own Hair

Download Article

1. 
   1
   Comb your hair out and straighten it. Before cutting your hair, make sure it’s free of any knots and tangles and that it falls straight. If you have straight hair, you can cut it dry or damp. If you have wavy or curly hair, wash it, dry it, and straighten it so that your cuts will be more precise and even.

   • If you have curly or wavy hair and don’t plan to style it straight, remember to cut it a little longer than you want it to be: once it’s wavy or curly again, it’ll be shorter.
2. 
   2
   Pull your hair back into a low ponytail. Part your hair down the middle. Pull it back into a low ponytail at the nape of your neck, then secure it with a hair tie. Make sure that the ponytail is neat and smooth, and that all your hairs are in elastic.
   Advertisement
3. 
   3
   Tie another elastic a few inches/centimeters below the first one. Smooth your ponytail down as much as you can, then wrap another elastic around it. Adding elastics gives you control before and as you cut. Depending on how long your hair is, and how short you plan on cutting it, you may need to add a third elastic below the second one.

   • If you don’t have extra elastics, just gently pull the first elastic down to right above the place you want to cut your hair.
4. 
   4
   Hold the ponytail in your fingers where you want to cut it, and cut. Make a V-shape with your fore and middle fingers, then close your fingers around the ponytail. Using sharp hairdressing shears, cut your hair slowly and carefully, a little bit at a time.

   • Make sure to cut an inch or so below the hair tie, rather than above, so that it’s easier to flatten out the hair between your fingers. Cutting above the hair tie, where your hair is thickest, will result in a choppier cut.
5. 
   5
   Undo the ponytail and check the shape. Turn around so that your back is facing the mirror, and hold another mirror up in front of you. Your hair will either have a rounded bottom edge or a slight curve. If this is not straight enough for you, proceed to the next step.
6. 
   6
   Part your hair down the center and make 2 ponytails. Drape the left side of your hair over your left shoulder, and the right side over your right shoulder. Tie them tightly, letting the hair hang over your shoulders.

   • If your hair is particularly thick or unruly, it into 4 ponytails to make it more manageable. Just make sure all ponytails are the same length and lie in front of your shoulders.
7. 
   7
   Pinch one ponytail in your fingers and cut. Grab a ponytail, then pinch it between your fore- and middle fingers as you did earlier, and drag your fingers downward at a slight upward angle (that is, with the angle higher nearer your shoulders and lower at your neck). Cut the hair below your fingers using the same process as before.

   • Cutting your hair at this angle will allow you to cut the hair from the back of your head shorter; when you brush your hair out, it will be the same length.
8. 
   8
   Repeat the process with each ponytail. To ensure that you’re cutting each ponytail at the same length, measure the uncut hair against the cut hair. Take the innermost strands from both the left and right sections. Note where the cut strand ends on the uncut strand with your fingers.
Advertisement

Method 2

Method 2 of 2:

Cutting Someone Else's Hair

Download Article

1. 
   1
   Dampen the person’s hair with a spray bottle. While some cuts are best done on dry hair, a straight-across haircut is best done on wet hair to ensure it’s as smooth, straight, and manageable as possible. You don't have to wash the person's hair with shampoo and conditioner, but it needs to be wet (but not soaking).

   • Keep in mind that however short you cut their hair, it will be a bit shorter when it’s fully dry.
2. 
   2
   Gather the top three-quarters of their hair into a bun. Use the handle of a rat-tail comb to create a neat part, then pull the hair into a bun at the top of their head. Clip the bun out of the way, or secure it with a hair tie. Leave the bottom portion of their hair loose.

   • Have the person sit in a tall chair so that their hair is at a comfortable cutting level for you.
3. 
   3
   Pinch a strand of loose hair in your fingers. Make a V-shape with your forefinger and middle fingers. Close your fingers against a 1 to 2 inches (2.5 to 5.1 cm)-wide strand in the middle of the loose hair: the middle strand of hair will be your guide for the rest of the hair.

   • You can also use a rat-tail comb to measure out the sections. This will prevent you from accidentally pulling down too hard on it.
4. 
   4
   Slide your fingers down the strand to where you want to cut. Keep your hand against the person's back and avoid creating any angle by pulling it away from the back. Make sure your fingers stay parallel to the part you made earlier and the floor.

   • Don’t twist your fingers upwards, flip the hair, or pull the strand away from the person's back. Doing so will cause a slight gradation.
5. 
   5
   Cut the hair off below your fingers. Use the length of your fingers as a guide. Make sure that you’re using sharp hairdressing shears for this; don’t use ordinary scissors.

   • Ensure the person is sitting straight with their face forward before you cut and that they’re not crossing their legs. Otherwise, you won't be able to cut their hair straight.
6. 
   6
   Gather another section of loose hair and measure it against the already-cut one. Take another ¹⁄₂ inch (1.3 cm)-wide section of hair. Add it to a few strands from the section that you already cut. Pinch the section between your fore- and middle fingers, like before. Slide your fingers down until the bottom edge is level with the cut strand.
7. 
   7
   Cut the hair, then pinch another strand. Measure the new strand up against the previous strand, and cut it. Continue in this manner until you have cut the entire bottom layer of hair.

   • Never pull the strands away from the person's back while cutting them. Keep them as close as possible to their back.
   • Measure up the left and right sides in the front to ensure that they are even.
8. 
   8
   Let down another layer of hair and clip the top layer of hair in a bun. Use the handle of a rat-tail comb to create another neat, horizontal part. Leave enough hair so that you can still see part of the previous layer beneath it. Gather the rest of the hair into a bun once again.
9. 
   9
   Measure the upper layer against the bottom one and cut it. Take a 1 to 2 inches (2.5 to 5.1 cm) section of hair from the new layer. Add a thin strand from the bottom layer to it and, using the cut hair as your guide, cut the new strand below your fingers as before, and repeat the process with the rest of the hair.

   • Measure the new strands against the previous ones and the new layer against the old one.
10. 
    10
    Dry the person's hair, then make any necessary adjustments. If you want to, you can wash the person's hair to get rid of any tiny snippets of hair. Blow dry the person's hair, then trim off any ends that stick out.

    • Since you cut all the hair from behind, the front strands may end up slightly uneven. To even them out, let the hair fall where it would naturally fall by the person’s shoulders and trim it using your fingers as a guide.
Advertisement

Expert Q&A

Search

Add New Question

• Question

  What are common mistakes when cutting long hair?

  

  Courtney Foster
  Licensed Cosmetologist

  Courtney Foster is a Licensed Cosmetologist, Certified Hair Loss Practitioner, and Cosmetology Educator based out of New York City. Courtney runs Courtney Foster Beauty, LLC and her work has been featured on The Wendy Williams Show, Good Morning America, The Today Show, The Late Show with David Letterman, and in East/West Magazine. She received her Cosmetology License from the State of New York after training at the Empire Beauty School - Manhattan.

  

  Courtney Foster

  Licensed Cosmetologist

  Expert Answer

  

  Thanks! We're glad this was helpful.
  Thank you for your feedback.
  If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn

  YesNo

  Not Helpful 3Helpful 3
• Question

  Could I also do this with dry hair?

  

  Community Answer

  You could, but it is harder to get a clean cut out of it, because the hair will move much more and won't stay put.

  Thanks! We're glad this was helpful.
  Thank you for your feedback.
  If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn

  YesNo

  Not Helpful 4Helpful 22
• Question

  Why can't normal scissors be used? I don't have hairdressing scissors.

  

  Community Answer

  You could use regular scissors; however, you would need to use new ones that haven't been used for paper or food products. Paper dull the blades of scissors, and therefore will rip hair out from the follicle instead of cutting the hair at the desired length.

  Thanks! We're glad this was helpful.
  Thank you for your feedback.
  If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn

  YesNo

  Not Helpful 2Helpful 24

See more answers

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Advertisement

Video

Tips

• Straight cuts aren't recommended for curly or wavy hair types due to the unique shape of each curl.
  Thanks

  Helpful2Not Helpful0
• If you have curly or wavy hair, and plan on straightening it after it’s cut, cut it while it is straight.
  Thanks

  Helpful1Not Helpful1
• Cut slowly and carefully. Remember, you can always cut off more hair if it’s still too long, but it’ll take a long time to grow it back if you cut too much off.
  Thanks

  Helpful2Not Helpful0

Show More Tips

Submit a Tip

All tip submissions are carefully reviewed before being published

Submit

Thanks for submitting a tip for review!

Advertisement

Things You'll Need

Cutting Your Own Hair

• Brush or comb
• Hair tie
• Hairdressing shears
• Mirrors

Cutting Someone Else's Hair

• Rat-tail comb
• Hair clips
• Hairdressing shears