How to Clean a Headphone Jack on a Phone, Laptop, & More

Are you having issues connecting headphones to your phone or other electronic device? When your headphone jack is left uncovered in your bag or pocket, it can easily accumulate dirt and lint. Without proper cleaning, you eventually may not be able to plug in your headphones. Headphone jacks and aux ports on stereos can be cleaned quickly and safely. Compressed air blows out debris, but you can also use a cotton swab for tough debris or a taped paperclip to remove lint. We'll walk you through 4 incredibly easy ways to clean your headphone jack.

Method 1

Method 1 of 4:

Cotton Swabs

Download Article

1
Buy cotton swabs. Cotton swabs, also known as Q-tips, are easy to find in any store where health and beauty products are sold. Try to get swabs that don't look very fluffy so the cotton isn't left behind in the jack or port. Swabs with thinner tips work better because they are easier to fit inside the jack.
- Make sure your device is powered off before you continue.
On one end of the swab, begin tearing or cutting off cotton from the tip. Make the tip as close to the width of the swab's middle portion as possible. Once the swab tip is this size, it should fit comfortably inside the jack.^{[1]XResearch source}
Advertisement
Don't jam the swab into the jack. Slowly push it in until it rests inside the hole. Spin the swab to brush off all sides of the jack. Remove the swab and most debris will fall out.
4
Swab with rubbing alcohol. For difficult debris, you can dip the swab in some rubbing alcohol. Make sure the swab is lightly coated, not soaked or dripping. Squeeze out excess moisture with a tissue or cloth first. Put the swab back inside the jack and spin it again.
- Rubbing alcohol can corrode the metal, so use it sparingly. You may want to let it sit and dry for a few minutes before putting it back in the jack.
5
Dry out the jack with a clean swab. The rubbing alcohol should dry quickly on its own. However, you can remove excess moisture to minimize the jack's exposure. Stick a clean swab into the jack. Leave it in there for a moment and spin it around to collect the alcohol.
- Wait at least an hour before powering your device back on.

Method 2

Method 2 of 4:

Compressed Air

Download Article

Compressed air, which can be found at electronics, office supplies, or computer stores, is used for clearing debris from computer parts and keyboards. Air is least likely to damage your jack since you don't have to put anything inside the hole other than the air.
Get the air dispensing opening right up next to the jack. Some bottles come with thin straws that stick out from the can. These may be easier for you to use since you can point the tube directly at the jack and focus the air into the small opening.
Press the button on the top of the can to start dispensing air. You should only need a blast or two to loosen most debris inside the jack. Make sure all it comes out of the hole.

Method 3

Method 3 of 4:

A Taped Paperclip

Download Article

1
Unfold a paperclip. Open up a paper clip so that one end is straight. Once straight, the paper clip can be used to scrape out debris. But since the metal can scratch the inside of the jack, you should never simply insert it into the port.
- A toothpick can also be used, but the pointed ends can also scratch the jack's interior.
- Needles are useful for reaching lint and large debris but can easily scratch the jack. Only use a needle as a last resort.
Use standard office tape (like Scotch or Sellotape). Tightly wrap the tape sticky side up around the straightened end of the paperclip. Before use, check to see that the tape is secure and won't come off.^{[2]XResearch source}
3
Gently insert the taped end of the paperclip into the jack. Slowly move the tape into position. Don't jam it in there. Reach for any debris you see. The tape forms a lint roller and will remove stuck debris and lint.
- After cleaning out the headphone jack with a taped paperclip, you may want to clean it out with a cotton swab, just for good measure.

Method 4

Method 4 of 4:

An Interdental Brush

Download Article

1
Purchase an interdental brush. These are small dental brushes with bristles on all sides of the tip which are typically used for cleaning braces. You can buy them at any drug store or health and beauty supply store.
- This can be useful for removing any corroded metal or rust that has accumulated on the inside of your headphone jack.
- Make sure your device is turned off before inserting a brush or anything dipped in alcohol.
To do so, dip the brush in some rubbing alcohol and then tap it a few times to remove excess alcohol. It should be damp but not soaking wet. If it is too wet, ring it out with a cloth or tissue.
Don't ram it in. Make sure you insert it gently as far as it will go. Then rotate it to loosen any debris left on the inside.
4
Repeat two or three times. Go ahead and reinsert the brush into the headphone jack and twist it a few times to make sure all the debris is cleaned out.
- Be sure to wait at least an hour before powering your device back on.

Community Q&A

Search

Add New Question

Question
I tried almost all of these and my phone is still in headphone mode. What do I do?
Community Answer
If nothing is working, you should consult the technical support department of your phone's manufacturer. There may be something easy they can do to fix it, or you may need to upgrade your phone.
Thanks! We're glad this was helpful.
Thank you for your feedback.
If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn
Yes No
Not Helpful 31 Helpful 33
Question
I tried everything but it won't connect my earphone. What do I do?
Rudy Toth
Community Answer
You need to get yourself a can of compressed air along with good ventilation in the room to clean out the headphone jack connector. There also adaptors that connect to the primary jack to bring down the size to 3.5mm jacks being a female adapter. Radio Shack use to sell these but, since RS is no longer in business. You need to seek them elsewhere on line maybe to obtain which are cheap and reliable.
Thanks! We're glad this was helpful.
Thank you for your feedback.
If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn
Yes No
Not Helpful 11 Helpful 6
Question
My headphones sort of bounce out of the headphone jack, and sound stops or comes out of the phone itself sometimes, instead of the headphones. Is it a dirty headphone jack or a problem with the phone?
Robert Lupas
Community Answer
It can be either a dirty headphone jack or a problem with the phone. First, try to clean it using this tutorial. Then, if it still doesn't work, it might be a problem with the phone. Try scanning the phone for viruses (they can affect the sound output) and try hard rebooting it or even doing a total reset. If the problem is still unsolved, take it to get a professional service done.
Thanks! We're glad this was helpful.
Thank you for your feedback.
If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn
Yes No
Not Helpful 20 Helpful 4