How to Bull Boots to a "British Army Shine"

Polishing boots is an art form. To get the best results, take your time and apply small layers. This is a week long process, not a last minute thing, especially if you want to get a mirror finish that will last and not fall off the first time you come to attention.

Part 1

Part 1 of 2:

Preparing for Bull Polishing

Download Article

1
Wear your boots. Getting your brand new boots out of the stores and then spending hours bulling them is just going to ruin them. Wear them in for a few weeks if possible.
- If you don't have time to wear them in, put them on and submerge them in hot water for 20 minutes or so. Then walk around; this will help speed up the process. Note they will take time to dry.
Again wear them whilst doing this but try not to scruff the toe or chip the boot; this will affect the end out come, so don't take them on the assault course.
Advertisement
Selvyt cloths are a good choice. Wash it a few times, and brush it with a nail brush and washing up liquid will make it softer and less likely to scratch your boot. Note that this can be done whilst doing first steps.
Get some black polish, but for a deeper shine, also buy a tin of dark brown to top the look off with.

Part 2

Part 2 of 2:

Bull Polishing

Download Article

You'll need a small bowl of water, your black and brown polish, Silver, and the boots.
Make sure it is flat on your fingers; twisting the access can help to tighten on fingers.
Wipe it until it's covered, using a circular motion of an inch diameter. Rub in until you think the polish is drying.
Do this by dipping your cloth on water and repeating the last step.
Each time, use less and less new black polish.
Do as you have done for the black layers; again stop when you think it's drying and removing any left over polish with water. Brown polish seems to be softer than black, so it fills the tiny holes you want to get rid off to make the best shine.
You don't want your hard work to crack and fall off.
Repeat daily until you get the results you want. This normally takes a week of around an hour a night to see good long lasting results.

Community Q&A

Search

Add New Question

Question
Does this work for brown boots as well?
vani samalla
Community Answer
Yes, it will. Bull polishing, bulling, spit polishing, or spit shining refers to a method for polishing leather products, even brown, in such a way as to give them an extremely high shine effect.
Thanks! We're glad this was helpful.
Thank you for your feedback.
If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn
Yes No
Not Helpful 3 Helpful 8

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Tips

If you need to do an uneven boot or damaged toe-capped boot, melting polish on a snoop and bulling with that is a good method, but again too thick layers will just fall off.
Thanks
Helpful1 Not Helpful0
Some say that applying a thick layer of polish and then using a blow torch to melt the polish to the boot for your first layer is effective, but it's obviously extreme. Proceed only with caution.
Thanks
Helpful2 Not Helpful1

Submit a Tip

All tip submissions are carefully reviewed before being published

Submit

Thanks for submitting a tip for review!

Warnings

If melting polish, realize it is highly flammable and you need to be in a ventilated room.
Thanks
Helpful10 Not Helpful3

Over-polishing when polish has dried will scratch your boot, lessening the shine. Apply a little more polish or water to lubricate your bulling action.
Thanks
Helpful7 Not Helpful3