Download ArticleDownload ArticleThis article was co-authored by Jurdy Dugdale, RN. Jurdy Dugdale is a Registered Nurse in Florida. She received her Nursing License from the Florida Board of Nursing in 1989.
There are 11 references cited in this article, which can be found at the bottom of the page.
This article has been fact-checked, ensuring the accuracy of any cited facts and confirming the authority of its sources.
This article has been viewed 78,273 times.
If a patient has been bitten by a wild animal, it is a good idea to give them the rabies vaccine to prevent them from developing rabies. This vaccine should always be administered by a healthcare professional. You can give this injection either before or after exposure to rabies. Prepare the vaccine immediately before administering it to a patient. Inject the vaccine into the deltoid (upper arm) muscles. Multiple doses of this vaccine must be spread out over a few weeks, so make plans with the patient for them to return.
Steps
Wash your hands before putting on gloves. Use warm water and antibacterial soap to wash your hands. Dry your hands with paper towels, and use the paper towel to turn off the faucet. Put on sterile gloves.[1]
Prepare the vaccine according to the instructions on the package insert. There are a few brands of rabies vaccine. Most come as a powder that must be mixed with sterile water. The package on the vaccine will indicate how much sterilized water you must mix with the powder. Roll the vial between your hands to gently mix the powder until it appears mostly clear.[2]- Always prepare the vaccine immediately before you are about to administer it.
- Make sure to check the expiration dates on both the powder and the water. If either is expired, do not use it.
Advertisement
Gather a clean syringe with a new 25-gauge needle. If you don’t have a pre-assembled syringe, attach a new needle to a clean syringe. Do not reuse needles from another vaccination. The size of the needle will depend on the age of the patient.[3]- For adults, use a needle that is between 1–1.5 inches (2.5–3.8 cm).
- For children over the age of 1, use a 1 inch (2.5 cm) needle.
- For children under the age of 1, use a needle between 7⁄8–1 inch (2.2–2.5 cm).
- If you are vaccinating multiple people at once, always use a separate syringe and needle for each injection.[4]
Fill the syringe with 1 dose of vaccine. Before filling the needle, pull back the plunger to measure the correct dose. Insert the syringe into the vial at a 90-degree angle and press down on the plunger. Flip over the vaccine bottle. Pull back the plunger to fill the syringe. Tap the barrel of the syringe and push gently on the plunger to release any air bubbles.[5]- In most cases, one dose of this vaccination is 1 ml of liquid, but depending on the brand of the vaccine and age of the patient, this may vary from 0.5 ml up to 2 ml.
Educate the patient about the vaccine before you administer it. Explain the procedure of giving a vaccine. Warn them that there might be some slight redness and swelling at the injection site. Allow the patient to ask any questions.[6]- Remind the patient that the vaccine is necessary if bitten by an animal that has a high risk of carrying rabies, such as a raccoon, squirrel, bat, or feral dog. You may want to emphasize that the vaccine is almost 100% effective in preventing the development of rabies. Once rabies develops, however, it is nearly almost always fatal.
- Tell the patient to watch out for side effects after the vaccine, such as confusion, dizziness, diarrhea, seizures, muscle weakness, burning at the injection site, or swelling around the eyes. Advise them to get immediate treatment if they notice these symptoms.
Choose an appropriate injection site. For anyone over the age of 1, give the vaccine on the deltoid muscle, which is the rounded muscle on the upper arm near the shoulder. Children under the age of 1 should be injected on the gluteal area on the outer thighs.- Make sure that the site is not bruised, wounded, or injured. If one arm is injured, inject the vaccine into the other arm.
- Never administer the vaccine to an adult on the gluteal area. This may reduce the effectiveness of the vaccine.
Wipe the chosen site with cotton balls soaked in rubbing alcohol. Move from the inner to the outer part of the injection site to eliminate harmful microorganisms. Let the area dry.[7]
Inject the vaccine into the muscle at a 90-degree angle. Press down on the plunger with your thumb to release the vaccine. Once you are finished, pull it out, keeping the syringe and needle straight as you do so.[8]
Apply pressure to the site with a cotton ball and apply a bandage. This will prevent any blood from leaking. Do not rub the area as this may irritate the injection site.
Discard the used syringe and needle in a puncture proof container. Do this immediately after giving the vaccine to prevent pricking yourself or the patient. Throw the cotton balls in the trash can.[9]
Remove the sterile gloves and wash your hands thoroughly. Do this with antibacterial soap and clean water. To avoid infections and transmission of diseases, never reuse needles or syringes. Always use a new set for each vaccination.[10]
Give 3 doses over 1 month for a pre-exposure vaccination. After the first dose on day 0, give the second dose on day 7 and the third dose on either day 21 or 28. The pre-exposure prophylaxis is usually given to people who face a high risk of rabies, such as wildlife workers and veterinarians.- With the pre-exposure vaccine, a few days difference in timing on the third dose does not matter.
Inject 4 doses over 2 weeks to an un-immunized patient after exposure. An un-immunized patient is someone who has not received the pre-exposure vaccine. The first injection is given on day 0. The next injections on days 3, 7, and 14. It is usually given to someone who has been bitten by wildlife or who has come into contact with bats.[11]- If there is a visible wound, you may also need to apply human rabies immune globulin to the wound. Consult your practice or hospital’s protocol for further information.
- With the post-exposure vaccination, it is important to stay on track with the timing of the dose.
- If the patient has a compromised immune system, provide an additional dose on day 28.
Give 2 doses over 1 week to an immunized patient after exposure. Even if a patient has received the pre-exposure prophylaxis, they still need a post-exposure vaccination if bitten. Administer the second dose 3-7 days after the first.[12]
Expert Q&A
Tips
Warnings
- If you are not a trained medical professional, do not attempt to administer the rabies vaccination yourself. Always see a doctor for treatment.Thanks
- While rare, anaphylactic shock can occur after a rabies vaccination. Monitor the patient for any immediate signs of allergic reaction, such as shortness of breath, swollen lips, or hives.Thanks
Things You'll Need
- Disposable gloves
- Syringe with 25-gauge needle
- Vaccine powder
- Sterile water
- Cotton balls
- Rubbing alcohol
- Adhesive bandage
- Sharps container
References
- ↑ https://www.cdc.gov/handhygiene/providers/index.html
- ↑ https://www.immunize.org/catg.d/p3040.pdf
- ↑ http://www.simcoemuskokahealth.org/docs/default-source/jfy-health-care-professionals/160824_Recommendations_for_Administration_of_Rabies_PEP
- ↑ https://www.cdc.gov/vaccines/hcp/admin/prepare-vaccines.html
- ↑ http://www.simcoemuskokahealth.org/docs/default-source/jfy-health-care-professionals/160824_Recommendations_for_Administration_of_Rabies_PEP
- ↑ https://patient.info/doctor/rabies-vaccination#nav-5
- ↑ https://www.ncbi.nlm.nih.gov/books/NBK138495/
- ↑ http://www.immunize.org/catg.d/p2020.pdf
- ↑ https://www.fda.gov/MedicalDevices/ProductsandMedicalProcedures/HomeHealthandConsumer/ConsumerProducts/Sharps/ucm263240.htm
About This Article
Medical Disclaimer
The content of this article is not intended to be a substitute for professional medical advice, examination, diagnosis, or treatment. You should always contact your doctor or other qualified healthcare professional before starting, changing, or stopping any kind of health treatment.
Before you administer a rabies vaccination, wash your hands and put on sterile gloves. Then, fill a clean, 25-gauge needle syringe with 1 dose of the vaccine per the package instructions. Once you've prepared the syringe, wipe the patient's deltoid muscle, which is the rounded muscle on the upper arm, with a cotton ball soaked in rubbing alcohol to sterilize the injection site. Inject the vaccine into the muscle at a 90-degree angle, then pull out the syringe and apply pressure to the area with a cotton ball to stop the bleeding. If the bleeding doesn't stop after a few seconds, cover the injection site with a bandage. For advice from our Medical co-author, like how to schedule future rabies vaccination doses, keep reading.
Reader Success Stories
"I did not know the deltoid muscle was preferred over the gluteal area. Very helpful data."
Did this article help you?
⚠️ Disclaimer:
Content from Wiki How English language website. Text is available under the Creative Commons Attribution-Share Alike License; additional terms may apply.
Wiki How does not encourage the violation of any laws, and cannot be responsible for any violations of such laws, should you link to this domain, or use, reproduce, or republish the information contained herein.
- - A few of these subjects are frequently censored by educational, governmental, corporate, parental and other filtering schemes.
- - Some articles may contain names, images, artworks or descriptions of events that some cultures restrict access to
- - Please note: Wiki How does not give you opinion about the law, or advice about medical. If you need specific advice (for example, medical, legal, financial or risk management), please seek a professional who is licensed or knowledgeable in that area.
- - Readers should not judge the importance of topics based on their coverage on Wiki How, nor think a topic is important just because it is the subject of a Wiki article.
