How to Launch a Rocket into Orbit in Kerbal Space Program

Download Article

Building, liftoff, and gravity turns in KSP

Download Article

Building a Ship

|

Launching Your Ship

|

Q&A

|

Tips

|

Warnings

|

Things You'll Need

Have you been trying to get into orbit for ages but lacked the know-how? Do you want to finally be able to fall towards Kerbin for an eternity? The popular space engineering sim can take a little learning, but with some persistence and insider knowledge, you'll be soaring through the stars in no time, and we'll show you how.

Part 1

Part 1 of 2:

Building a Ship

Download Article

Getting to space and getting to orbit are two very different things. Getting to space means you simply leave Kerbin's atmosphere by going above 70 kilometers (43 mi). Getting to orbit involves gaining appropriate lateral velocity (speeding up side-ways) while also propelling yourself vertically.
Everyone has their own style of ship-building; where one persons rocket may have 20 elaborate stages, another players ship may only have two stages and still be able to get just as high an orbit. Try playing around with a few stock ships and ships from the forums. If you find a design you like, adapt it to suit your style and/or needs.
Advertisement
The first being the boost stage. This stage is your least efficient stage with the most power and biggest rockets. The 'Mainsail' engine or the �LV-T45 for a small rocket would be perfect. Solid rocket boosters also provide high thrust but remember that you can't turn them off! Your transfer stage should kick in as you approach the 900m/s mark when you are almost tilted over towards the horizon. This will push your apoapsis up to around 70–100 kilometers (43–62 mi). Your third stage or orbital module should be used only to circularise your orbit and de-orbit and an LV-909 or Poodle engine attached to a small fuel tank (like the FL-T400 or X200-16) will be fine.
'Delta-V' means 'Change in velocity' and is measured in m/s. Your delta-V is linked with the fuel capacity, weight and efficiency of your rocket. You will need around 4500m/s (4700m/s with safety margin) Delta-V to get to orbit around Kerbin. To find how much Delta-V your rocket has, use this formula: (http://wiki.kerbalspaceprogram.com/wiki/Cheat_Sheet#Delta-v_.28.CE.94v.29)
Ok, to do this you are going to need to think big. KSP is not for the faint of heart, It's a giant universe out there, get ready for it!

Part 2

Part 2 of 2:

Launching Your Ship

Download Article

At this stage you simply want it to go straight up until you reach an altitude of 10 kilometers (6.2 mi) Consider turning SAS on and keeping your thrust at 2/3rds for lighter rockets. (depending on the weight of the rocket). Obviously, some rocket designs will require full thrust at launch, it is simply good practice to not exceed terminal velocity so that you don't waste fuel. Speed should be 120m/s at 1 kilometer (0.62 mi) and let it slowly increase
The gravity turn is the manoeuvre that will start giving you lateral velocity. You will want to tilt over to about 45 degrees east(right), this angle will allow your craft to continue to rise into the skies while gaining that needed lateral velocity. It is always good practice to launch your rockets into an anti-clockwise orbit (an eastward gravity turn) as this will let the planets rotational velocity add to your orbital velocity.
Your apoapsis is the highest point in your orbit and is marked in the map view by 'Ap'. you can hover over the marker to see its altitude or you can click on it to see it without having to hover over it. 70 kilometers (43 mi) is the altitude at which Kerbin's atmosphere ends, if your apoapsis is under this altitude, you will not be able to achieve a stable orbit as friction from the atmosphere will cause your craft to slow down and fall back to the rocky ground.
'Coasting' just means 'hit the time warp!'. You will want to warp to your apoapsis for your next burn.
At this point you will be changing your sub-orbital trajectory into an orbital trajectory. You will do this by pointing 'Pro-Grade' and burning till your periapsis>70 kilometers (43 mi).
If you have followed these steps correctly, you should be looking at a rather round planet! Well done!
Remember to come back home, point the ship with WASD at the retrograde marker, the yellow circle with the cross through it(against your direction of travel) and burn until your periapsis is below about 20 kilometers (12 mi).

Community Q&A

Search

Add New Question

Question
How can I stop my rocket from spinning out?
Community Answer
Try adding wings or fins near the bottom, top, or both ends of your rocket. Be sure to add an appropriately sized SAS module somewhere on your rocket, likely near or conected to the command pod or probe and enable it with T. If you suddenly spin out during this, try not to move too much during liftoff, or it's possible you've ran out of electric charge. Try changing your design if it continues to be a problem.
Thanks! We're glad this was helpful.
Thank you for your feedback.
If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn
Yes No
Not Helpful 5 Helpful 11
Question
Should I add solar panels to the actual rocket if I am going somewhere like the moon?
TomPN
Top Answerer
Or RTG's, but solar panels are preferred. Remember to add batteries as well.
Thanks! We're glad this was helpful.
Thank you for your feedback.
If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn
Yes No
Not Helpful 1 Helpful 6
Question
When do I preform the turn and how long do I keep the turn? Also, how do I stop my apoapsis from growing in space?
Community Answer
It depends on the drag, thrust, and mass of your vessel. You continue the turn until you achieve orbit. To stop your apoapsis from growing, you stop burning prograde.
Thanks! We're glad this was helpful.
Thank you for your feedback.
If How.com.vn has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission.Support How.com.vn
Yes No
Not Helpful 11 Helpful 8

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Tips

Periapsis - Lowest point in an orbit (Marked by Pe in map view)
Thanks
Helpful0 Not Helpful0
Apoapsis - Highest point in an orbit (Marked by Ap in map view)
Thanks
Helpful1 Not Helpful1
Pro-Grade - To point Pro-Grade is to point in the direction of travel. pro-grade is indicated on the nav-ball by a yellow marker (without a cross through it)
Thanks
Helpful1 Not Helpful0

Show More Tips

Submit a Tip

All tip submissions are carefully reviewed before being published

Submit

Thanks for submitting a tip for review!

Warnings

This may take several attempts, don't get upset if you can't get it first, second or 25th time. Just keep at it!
Thanks
Helpful11 Not Helpful5
Keep an eye on your apoapsis in map view as you make you circularization burn, if it goes too far ahead of you, tilt down. if it goes too far behind you, tilt up. You want your apoapsis to be right on top of you till the moment you get your periapsis above 70 kilometers (43 mi)
Thanks
Helpful7 Not Helpful4